Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
techtalk:evo:susp03a [2020/06/16 23:13] hippysmack [Bearing Outer Races] |
techtalk:evo:susp03a [2020/06/17 02:32] (current) hippysmack [Inspecting the Swingarm and Parts] |
||
|---|---|---|---|
| Line 46: | Line 46: | ||
| Check that the swingarm isn't warped, damaged or rusted. \\ | Check that the swingarm isn't warped, damaged or rusted. \\ | ||
| + | |||
| + | {{:techtalk:evo:susp:swingarm_maintenance_36_by_hippysmack.jpg?direct&300|}} ((photo by Hippysmack)) \\ | ||
| + | |||
| Remove the pivot bolt spacer and inspect both the spacer and it's bushing in the left pivot for damage or pitting. \\ | Remove the pivot bolt spacer and inspect both the spacer and it's bushing in the left pivot for damage or pitting. \\ | ||
| Line 56: | Line 59: | ||
| Hopefully your bearings won't look as bad as the ones below. You can spray them down with brake cleaner to clean off the old grease. \\ | Hopefully your bearings won't look as bad as the ones below. You can spray them down with brake cleaner to clean off the old grease. \\ | ||
| - | After cleanup, these bearings sis not roll smooth (bumps felt while turning) so they had to be replaced. \\ | + | After cleanup, these bearings did not roll smooth (bumps felt while turning) so they had to be replaced. \\ |
| {{:techtalk:evo:susp:swingarm_maintenance_19_by_hippysmack.jpg?direct&300|}} {{:techtalk:evo:susp:swingarm_maintenance_20_by_hippysmack.jpg?direct&300|}} | {{:techtalk:evo:susp:swingarm_maintenance_19_by_hippysmack.jpg?direct&300|}} {{:techtalk:evo:susp:swingarm_maintenance_20_by_hippysmack.jpg?direct&300|}} | ||
| Line 112: | Line 115: | ||
| The best tools ended up being a flat aluminum scrap piece and a hammer to 'set' the races in straight and a threaded rod and socket press to pull the races home. \\ | The best tools ended up being a flat aluminum scrap piece and a hammer to 'set' the races in straight and a threaded rod and socket press to pull the races home. \\ | ||
| Just slight tapping was all that was required to get them started. \\ | Just slight tapping was all that was required to get them started. \\ | ||
| + | |||
| + | The races will have a certain resistance when pressing them in. You'll feel the resistance and the races moving. \\ | ||
| + | If the resistance changes drastically (tightens suddenly), STOP, remove the tool and find out why. \\ | ||
| {{:techtalk:ref:tools:swingarm_bearing_race_installation_6_by_hippysmack.jpg?direct&300|}} {{:techtalk:ref:tools:swingarm_bearing_race_installation_7_by_hippysmack.jpg?direct&300|}} \\ | {{:techtalk:ref:tools:swingarm_bearing_race_installation_6_by_hippysmack.jpg?direct&300|}} {{:techtalk:ref:tools:swingarm_bearing_race_installation_7_by_hippysmack.jpg?direct&300|}} \\ | ||
