Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
techtalk:evo:transfinal01 [2019/06/10 20:29] ixl2relax |
techtalk:evo:transfinal01 [2019/06/10 20:36] ixl2relax [Sportster Transmission Servicing] |
||
---|---|---|---|
Line 5: | Line 5: | ||
\\ | \\ | ||
- | ====== Sportster Transmission Servicing ===== | ||
- | * [[techtalk:ref:svcproc10|1986-1990 4 Speed Transmission Removal / Inspection / Installation]] | + | \\ |
- | * [[techtalk:ref:svcproc11|1991-2003 5 Speed Transmision Removal / Inspection / Installation]] | + | |
- | * [[techtalk:ref:svcproc12|2004-later 5 Speed Transmission Removal / Inspection / Installation]] | + | \\ |
+ | |||
+ | \\ | ||
\\ | \\ | ||
Line 100: | Line 101: | ||
This [[http://xlforum.net/forums/showthread.php?t=1931756|XLForum Thread]] was used for collecting the above information. Thanks to those who contributed, especially Sirrom1. | This [[http://xlforum.net/forums/showthread.php?t=1931756|XLForum Thread]] was used for collecting the above information. Thanks to those who contributed, especially Sirrom1. | ||
+ | \\ | ||
====== Belt Conversion Kits ====== | ====== Belt Conversion Kits ====== | ||
Line 119: | Line 121: | ||
- | \\ | ||
- | \\ | ||
- | \\ | ||
- | |||
- | |||
- | * Reference: | ||
- | * http://xlforum.net/forums/showthread.php?t=1931756 | ||
- | |||
- | * | ||
\\ | \\ | ||
Line 133: | Line 126: | ||
====== Caution: Aluminum Drive Sprockets ====== | ====== Caution: Aluminum Drive Sprockets ====== | ||
- | {{ :techtalk:evo:transfinal:finaldrivesprocket-alum-failure-scuba10jdl.jpg?300|}} | ||
- | Some folks have had a problem with aluminum aftermarket pulleys that wear excessively. It may be an occassional fault in the anodizing or something more prevalent. Simply be aware of this potential problem. ((see Scuba10jdl's comments here: http://xlforum.net/forums/showthread.php?t=2073711)) | ||
- | \\ | + | Some folks have had a problem with aluminum aftermarket pulleys that wear excessively. It may be an occassional fault\\ |
+ | in the anodizing or something more prevalent. Simply be aware of this potential problem. ((see Scuba10jdl's comments here: http://xlforum.net/forums/showthread.php?t=2073711))\\ | ||
+ | {{:techtalk:evo:transfinal:finaldrivesprocket-alum-failure-scuba10jdl.jpg?300|}} | ||
- | \\ | ||
\\ | \\ | ||
- | |||
- | \\ | ||
- | |||
- | \\ | ||
- | |||
- | \\ | ||
- | |||
[[:techtalk:menu|{{:techtalk:gototechnicalmenu.jpg|}}]] | [[:techtalk:menu|{{:techtalk:gototechnicalmenu.jpg|}}]] |