Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
techtalk:evo:transfinal04 [2019/06/11 08:15] ixl2relax [Shifter Assembly] |
techtalk:evo:transfinal04 [2019/06/11 08:44] ixl2relax [Shifter Assembly] |
||
---|---|---|---|
Line 12: | Line 12: | ||
===== Shifter Assembly ===== | ===== Shifter Assembly ===== | ||
- | {{:techtalk:evo:transfinal:shifter-assemby-04later.jpg?400|}}((pic from AB,Frank http://xlforum.net/forums/showthread.php?t=1799188)) | + | {{:techtalk:evo:transfinal:shifter-assemby-04later.jpg?400|}}((pic from AB,Frank http://xlforum.net/forums/showthread.php?t=1799188)) {{:techtalk:evo:transfinal:shiftershaft-oilseal-37107-06-manborn.jpg?400|}} {{:techtalk:evo:transfinal:shiftershaft-bushing-40574-06.jpg?200|}} |
- | 2004-2005 vs 2006+ Shifter Assembly | + | **2004-2005 vs 2006+ Shifter Assembly**\\ |
Note the following part number differences between 04-05 and 06-later. The 06-later shifter shaft is larger than the previous version and therefore the hole in the primary cover is larger & the bushing & oil seal is different. | Note the following part number differences between 04-05 and 06-later. The 06-later shifter shaft is larger than the previous version and therefore the hole in the primary cover is larger & the bushing & oil seal is different. | ||
Line 30: | Line 30: | ||
\\ | \\ | ||
+ | On all models: | ||
+ | The oil seal can be removed without removing the primary cover - remove the lever, then use a pick or screwdriver to pry the seal out of the cavity. | ||
+ | |||
+ | On installs, be sure to put tape over the splines on the shifter shaft before installing the oil seal to prevent the splines from cutting the seal. | ||
+ | |||
+ | To increase the tightness of the oil seal, after installing the rubber washer, you might install one or two o-rings to take up the gap between the shift lever and the washer. The o-rings do not seal against leaking oil but, instead, they put additional pressure on the oil seal in the primary cover cavity, which does help to seal against leaks. | ||
+ | |||
+ | {{:techtalk:evo:transfinal:shiftershaft-tapeoversplines-manborn.jpg?335|}} | ||
+ | {{:techtalk:evo:transfinal:shiftershaft-oringmod-4pac.jpg?400|}} | ||
+ | |||
\\ | \\ | ||