Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
techtalk:evo:transfinal04 [2019/06/11 08:53] ixl2relax [Shifter Assembly] |
techtalk:evo:transfinal04 [2019/06/11 08:59] ixl2relax [Shifter Assembly] |
||
---|---|---|---|
Line 33: | Line 33: | ||
On all models: | On all models: | ||
The oil seal can be removed without removing the primary cover - remove the lever, then use a pick or screwdriver to pry the seal out of the cavity. | The oil seal can be removed without removing the primary cover - remove the lever, then use a pick or screwdriver to pry the seal out of the cavity. | ||
+ | |||
+ | The Oil Seal is installed first, followed by the washer/spacer\\ | ||
+ | (NOTE that the parts manual for 2004 & 2005 shows the Rubber Washer installed first & then the Oil Seal - but this is **WRONG!**) | ||
On installs, be sure to put tape over the splines on the shifter shaft before installing the oil seal to prevent the splines from cutting the seal. | On installs, be sure to put tape over the splines on the shifter shaft before installing the oil seal to prevent the splines from cutting the seal. | ||
Line 40: | Line 43: | ||
{{:techtalk:evo:transfinal:shiftershaft-tapeoversplines-manborn.jpg?335|}} | {{:techtalk:evo:transfinal:shiftershaft-tapeoversplines-manborn.jpg?335|}} | ||
{{:techtalk:evo:transfinal:shiftershaft-oringmod-4pac.jpg?400|}} | {{:techtalk:evo:transfinal:shiftershaft-oringmod-4pac.jpg?400|}} | ||
+ | |||
+ | Some XLForum reference threads:\\ | ||
+ | http://xlforum.net/forums/showthread.php?t=254258\\ | ||
+ | http://xlforum.net/forums/showthread.php?t=79795\\ | ||
+ | http://xlforum.net/forums/showthread.php?t=1560232 (pics of '04 & '06 primary cover)\\ | ||
+ | http://xlforum.net/forums/showthread.php?t=548729\\ | ||
+ | http://xlforum.net/forums/showthread.php?t=1218730\\ | ||
+ | |||
\\ | \\ |