Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
techtalk:ih:carb01r [2019/10/20 06:35] hippysmack [Fast Idle Cam Kit (76-up)] |
techtalk:ih:carb01r [2020/04/01 20:17] hippysmack [IH: Carburetor, Intake Manifold & Exhaust Systems - Sub-01R] |
||
---|---|---|---|
Line 24: | Line 24: | ||
{{:techtalk:ih:carb:keihin_buttefly_ac_side_functions_by_spuggy_-_annotated_by_hippysmack.jpg?direct&300|}} ((photo by spuggy of the XLFORUM, annotated by Hippysmack http://xlforum.net/forums/showthread.php?p=5694195&highlight=keihin#post5694195)) | {{:techtalk:ih:carb:keihin_buttefly_ac_side_functions_by_spuggy_-_annotated_by_hippysmack.jpg?direct&300|}} ((photo by spuggy of the XLFORUM, annotated by Hippysmack http://xlforum.net/forums/showthread.php?p=5694195&highlight=keihin#post5694195)) | ||
- | |||
- | ====== Service Bulletin Information ====== | ||
Line 154: | Line 152: | ||
|{{:techtalk:ih:carb:keihin_butterfly_carb_2_by_hopper.jpg?direct&300|}}| | |{{:techtalk:ih:carb:keihin_butterfly_carb_2_by_hopper.jpg?direct&300|}}| | ||
- | ==== Fast Idle Cam Kit (76-up) ==== | + | ==== Choke Shaft and Plastic Parts (76-E78) ==== |
- | A kit was available for 76-78 carbs to adapt for a fast idle cam. It was also available as a replacement for 79-up carbs. \\ | + | Kits were available from the MoCo for 76-78 FX & FL carbs to adapt for a fast idle cam. It was also available as a replacement for 79-up carbs. \\ |
- | The Choke Shaft Kit is (27045-78) and the Plastic Parts kit (27046-78). \\ | + | The Choke Shaft Kit is (27045-78) and the Plastic Parts kit (27046-78) as shown below (with the parts list including 3 springs, 2 clips and 2 washers). \\ |
{{:techtalk:ih:carb:keihin_choke_shaft_kit_27045-78.jpg?direct&300|}} {{:techtalk:ih:carb:keihin_plastic_parts_kit_27046-78.jpg?direct&300|}} \\ | {{:techtalk:ih:carb:keihin_choke_shaft_kit_27045-78.jpg?direct&300|}} {{:techtalk:ih:carb:keihin_plastic_parts_kit_27046-78.jpg?direct&300|}} \\ | ||
The ball under the choke lever drive must ride in the detents on the bottom of the choke lever drive. \\ | The ball under the choke lever drive must ride in the detents on the bottom of the choke lever drive. \\ |