Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
techtalk:ih:carb01r [2019/10/15 00:33] hippysmack [76-78 38mm Keihin's] |
techtalk:ih:carb01r [2019/10/16 02:32] hippysmack [76-78 38mm Keihin's] |
||
---|---|---|---|
Line 427: | Line 427: | ||
Any wiring that that may get too hot / catch fire doesn't need gas nearby. \\ | Any wiring that that may get too hot / catch fire doesn't need gas nearby. \\ | ||
- | While installing the accelerator pump, the diaphragm goes on first, then spring, then cover. \\ | + | |After adjusting. ((photo by Hopper of the XLFORUM http://xlforum.net/forums/showthread.php?t=276157&page=3))|Accelerator pump from the outside. \\ (see caution above) ((photo by Hopper of the XLFORUM http://xlforum.net/forums/showthread.php?t=276157&page=3))| |
- | Make sure those two square section O-rings are in place and in good condition. Else, gas will leak out there instead of getting squirted into your engine. \\ | + | |{{:techtalk:ih:carb:keihin_butterfly_carb_15_by_hopper.jpg?direct&300|}}|{{:techtalk:ih:carb:keihin_butterfly_carb_16_by_hopper.jpg?direct&300|}}| |
- | + | ||
- | |After adjusting. ((photo by Hopper of the XLFORUM http://xlforum.net/forums/showthread.php?t=276157&page=3))|Accelerator pump from the outside. \\ (see caution above) ((photo by Hopper of the XLFORUM http://xlforum.net/forums/showthread.php?t=276157&page=3))|Check position of O-rings. ((photo by Hopper of the XLFORUM http://xlforum.net/forums/showthread.php?t=276157&page=3))| | + | |
- | |{{:techtalk:ih:carb:keihin_butterfly_carb_15_by_hopper.jpg?direct&300|}}|{{:techtalk:ih:carb:keihin_butterfly_carb_16_by_hopper.jpg?direct&300|}}|{{:techtalk:ih:carb:keihin_butterfly_carb_17_by_hopper.jpg?direct&300|}}| | + | |
===== Andrews High Flow Accelerator Pump (Keihin butterfly) ===== | ===== Andrews High Flow Accelerator Pump (Keihin butterfly) ===== |