Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
techtalk:ih:engctl02 [2019/04/19 20:32] ixl2relax [Sportster Starter Motors] |
techtalk:ih:engctl02 [2019/06/23 01:39] hippysmack [Starters] |
||
---|---|---|---|
Line 6: | Line 6: | ||
====== Starters ====== | ====== Starters ====== | ||
+ | ===== Sub-Documents ===== | ||
+ | * . . . [[techtalk:ih:engctl02a|Bench Testing an Ironhead Solenoid]] \\ | ||
===== Starter Motor Variations ===== | ===== Starter Motor Variations ===== | ||
Line 14: | Line 15: | ||
| 67-73 | Prestolite only. | Separate Solenoid | | | 67-73 | Prestolite only. | Separate Solenoid | | ||
- | | 74-E76 | EITHER Presolite or Hitachi. | Separate Solenoid | | + | | 74-E76 | EITHER Prestolite or Hitachi. | Separate Solenoid | |
| L76-80 | Prestolite only. | Separate Solenoid | | | L76-80 | Prestolite only. | Separate Solenoid | | ||
| 81-later | Nippon Denso | Solenoid Attached | | | 81-later | Nippon Denso | Solenoid Attached | | ||
Line 42: | Line 43: | ||
http://xlforum.net/forums/showthread.php?t=1521782 - Dr. Dick Post#4 quoted above\\ | http://xlforum.net/forums/showthread.php?t=1521782 - Dr. Dick Post#4 quoted above\\ | ||
http://xlforum.net/forums/showthread.php?t=1715008\\ | http://xlforum.net/forums/showthread.php?t=1715008\\ | ||
+ | http://xlforum.net/forums/showthread.php?t=1752598\\ | ||
+ | |||
\\ | \\ | ||
Line 49: | Line 52: | ||
For additonal information, see the [[techtalk:evo:engctl02|Evo Section - Starter/Solenoid]] | For additonal information, see the [[techtalk:evo:engctl02|Evo Section - Starter/Solenoid]] | ||
+ | | Prestolite Starter. ((photos by sifty of the XLFORUM http://xlforum.net/forums/showthread.php?t=1592463&page=27)) || | ||
+ | |{{:techtalk:ih:engctl:prestolite_starter_1_by_sifty.jpg?direct&300|}}|{{:techtalk:ih:engctl:prestolite_starter_11_by_sifty.jpg?direct&300|}}| | ||
\\ | \\ | ||
Line 55: | Line 59: | ||
====== Solenoids ====== | ====== Solenoids ====== | ||
+ | 67 and Up XLH Starter solenoid (71469-65) \\ | ||
+ | Below, the 1/4" solenoid mounting threads were stripped (nut on the top bolt) so they were tapped out for 8mm cap screws. ((photo by sifty of the XLFORUM http://xlforum.net/forums/showthread.php?t=1592463&page=27)) \\ | ||
+ | 8mm x 1.25 threads have almost exactly the same thread pitch as the original 1/4" thread. \\ | ||
+ | Then the mounting bracket and and spacer were drilled 8mm and the solenoid was installed using allen head cap screws and spring washers. \\ | ||
+ | |||
+ | | Starter solenoid (71469-65) ((photo by sifty of the XLFORUM http://xlforum.net/forums/showthread.php?t=1592463&page=27)) | | ||
+ | |{{:techtalk:ih:engctl:solenoid_switch_1_by_sifty.jpg?direct&300|}}|{{:techtalk:ih:engctl:solenoid_switch_2_by_sifty.jpg?direct&300|}}|{{:techtalk:ih:engctl:solenoid_switch_3_by_sifty.jpg?direct&300|}}| | ||
\\ | \\ |