Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
techtalk:ih:engctl02 [2020/03/09 09:48] ixl2relax [Solenoid] |
techtalk:ih:engctl02 [2021/06/27 13:12] ixl2relax [Solenoid] |
||
---|---|---|---|
Line 88: | Line 88: | ||
Using an ohm meter would give really confusing readings because you'd see continuity to both case ground and the starter terminal from the solenoid windings connection. | Using an ohm meter would give really confusing readings because you'd see continuity to both case ground and the starter terminal from the solenoid windings connection. | ||
- | 67 and Up XLH Starter solenoid (71469-65) \\ | + | \\ |
+ | |||
+ | **67 and Up XLH Starter solenoid (71469-65)**\\ | ||
Below, the 1/4" solenoid mounting threads were stripped (nut on the top bolt) so they were tapped out for 8mm cap screws. ((photo by sifty of the XLFORUM http://xlforum.net/forums/showthread.php?t=1592463&page=27)) \\ | Below, the 1/4" solenoid mounting threads were stripped (nut on the top bolt) so they were tapped out for 8mm cap screws. ((photo by sifty of the XLFORUM http://xlforum.net/forums/showthread.php?t=1592463&page=27)) \\ | ||
8mm x 1.25 threads have almost exactly the same thread pitch as the original 1/4" thread. \\ | 8mm x 1.25 threads have almost exactly the same thread pitch as the original 1/4" thread. \\ | ||
- | Then the mounting bracket and and spacer were drilled 8mm and the solenoid was installed using allen head cap screws and spring washers. \\ | + | Then the mounting bracket and and spacer were drilled 8mm and the solenoid was installed using allen head cap screws and spring washers. |
| Starter solenoid (71469-65) ((photo by sifty of the XLFORUM http://xlforum.net/forums/showthread.php?t=1592463&page=27)) ||| | | Starter solenoid (71469-65) ((photo by sifty of the XLFORUM http://xlforum.net/forums/showthread.php?t=1592463&page=27)) ||| |