Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
techtalk:ih:engctl02 [2019/04/19 21:49]
ixl2relax [Starter Motor Variations]
techtalk:ih:engctl02 [2019/06/23 01:39] (current)
hippysmack [Starters]
Line 6: Line 6:
  
 ====== Starters ====== ====== Starters ======
 +===== Sub-Documents ​ ===== 
 +* . . . [[techtalk:​ih:​engctl02a|Bench Testing an Ironhead Solenoid]] \\
 ===== Starter Motor Variations ===== ===== Starter Motor Variations =====
  
Line 51: Line 52:
 For additonal information,​ see the [[techtalk:​evo:​engctl02|Evo Section - Starter/​Solenoid]] For additonal information,​ see the [[techtalk:​evo:​engctl02|Evo Section - Starter/​Solenoid]]
  
 +|  Prestolite Starter. ((photos by sifty of the XLFORUM http://​xlforum.net/​forums/​showthread.php?​t=1592463&​page=27)) ​ || 
 +|{{:​techtalk:​ih:​engctl:​prestolite_starter_1_by_sifty.jpg?​direct&​300|}}|{{:​techtalk:​ih:​engctl:​prestolite_starter_11_by_sifty.jpg?​direct&​300|}}|
  
 \\ \\
Line 57: Line 59:
  
 ====== Solenoids ====== ====== Solenoids ======
 +67 and Up XLH Starter solenoid (71469-65) \\
 +Below, the 1/4" solenoid mounting threads were stripped (nut on the top bolt) so they were tapped out for 8mm cap screws. ((photo by sifty of the XLFORUM http://​xlforum.net/​forums/​showthread.php?​t=1592463&​page=27)) \\
 +8mm x 1.25 threads have almost exactly the same thread pitch as the original 1/4" thread. \\
 +Then the mounting bracket and and spacer were drilled 8mm and the solenoid was installed using allen head cap screws and spring washers. \\
 +
 +|  Starter solenoid (71469-65) ((photo by sifty of the XLFORUM http://​xlforum.net/​forums/​showthread.php?​t=1592463&​page=27)) ​ |
 +|{{:​techtalk:​ih:​engctl:​solenoid_switch_1_by_sifty.jpg?​direct&​300|}}|{{:​techtalk:​ih:​engctl:​solenoid_switch_2_by_sifty.jpg?​direct&​300|}}|{{:​techtalk:​ih:​engctl:​solenoid_switch_3_by_sifty.jpg?​direct&​300|}}|
  
 \\ \\