Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Last revision Both sides next revision | ||
|
techtalk:ih:engctl03 [2020/04/30 20:34] hippysmack [Sub-Documents] |
techtalk:ih:engctl03 [2021/12/11 08:24] hippysmack [Sub-Documents] |
||
|---|---|---|---|
| Line 36: | Line 36: | ||
| Some early production 1980 models had the same plug hole and bushing for the kicker shaft as the 79 models had. ((Hapster of the XLFORUM)) \\ | Some early production 1980 models had the same plug hole and bushing for the kicker shaft as the 79 models had. ((Hapster of the XLFORUM)) \\ | ||
| + | We have confirmation of an early 1980 case with crankcase# (780 347 084), machined December 13, 1979 does have the hole for the kicker. ((OutlawTexan67 of the XLFORUM http://xlforum.net/forums/showthread.php?t=47136&page=3)) \\ | ||
| Some 1980 models came with a 1979 engine with 1980 numbers that match the H9 frame - (1979). \\ | Some 1980 models came with a 1979 engine with 1980 numbers that match the H9 frame - (1979). \\ | ||
| So it all depends on if you have a left over production 1979 engine installed. \\ | So it all depends on if you have a left over production 1979 engine installed. \\ | ||
| Line 41: | Line 42: | ||
| ^Kick Start Kit|| | ^Kick Start Kit|| | ||
| |1979-E1980|33058-79^ | |1979-E1980|33058-79^ | ||
| + | |||
| + | |||
| + | ---- | ||
| + | |||
| + | 1968-E1980 kicker hole plug. \\ | ||
| + | |||
| + | {{:techtalk:ih:engctl:1974_xlh_kicker_hole_plug_by_74_xlh_winchester_va.jpg?direct&300|}} ((photos by 74_XLH_WINCHESTER_VA of the XLFORUM, combined by Hippysmack, http://xlforum.net/forums/showthread.php?threadid=727978)) \\ | ||
| \\ | \\ | ||
| [[:techtalk:menu|{{:techtalk:gototechnicalmenu.jpg|}}]] | [[:techtalk:menu|{{:techtalk:gototechnicalmenu.jpg|}}]] | ||
