Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
techtalk:ih:oil01 [2019/05/10 02:08] hippysmack [Checking Oil Pressure] |
techtalk:ih:oil01 [2019/06/14 03:40] hippysmack [Oil Lines to the Rockers] |
||
---|---|---|---|
Line 408: | Line 408: | ||
|Oil path of 85 style cam cover ((photo by billeuze of the XLFORUM http://xlforum.net/forums/showthread.php?t=1103082))| | |Oil path of 85 style cam cover ((photo by billeuze of the XLFORUM http://xlforum.net/forums/showthread.php?t=1103082))| | ||
|{{:techtalk:ih:oil:85_cam_cover_1_by_billeuze_annotated_by_hippysmack.jpg?direct&300|}}| | |{{:techtalk:ih:oil:85_cam_cover_1_by_billeuze_annotated_by_hippysmack.jpg?direct&300|}}| | ||
+ | |||
+ | ===== Oil Lines to the Rockers ===== | ||
+ | There are rubber grommets on both ends of the oil lines. ((IronMick of the XLFORUM http://xlforum.net/forums/showthread.php?t=753175&highlight=split+rocker+box)) \\ | ||
+ | Some guys install two on each end, which is a wrong thing to do. \\ | ||
+ | Sometimes the rubber from an improperly installed grommet plugs the oil line. \\ | ||
+ | Before going into the gearcase (to check for low / no oil to the rocker boxes); \\ | ||
+ | Remove both oil lines, and check the rubbers on both ends of each. \\ | ||
+ | |||
+ | ===== Rocker Box ===== | ||
+ | The feed to the rockers is not a large diameter passage and not a lot of oil goes to the rocker gear. ((Ferrous Head of the XLFORUM http://xlforum.net/forums/showthread.php?t=753175&highlight=split+rocker+box)) \\ | ||
+ | But if you pull the lines off with the engine running you should be getting a good steady flow out of them. \\ | ||
====== Bottom End Oiling ====== | ====== Bottom End Oiling ====== |