Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
Next revision Both sides next revision
techtalk:ih:oil03f [2021/06/25 05:05]
hippysmack [Breather Gears]
techtalk:ih:oil03f [2021/06/26 04:51]
hippysmack
Line 71: Line 71:
 |{{:​techtalk:​ih:​oil:​scavaenge_gear_sets_1_by_dr_dick.jpg?​direct&​220|}}|{{:​techtalk:​ih:​oil:​scavaenge_gear_sets_2_by_dr_dick.jpg?​direct&​300|}}|{{:​techtalk:​ih:​oil:​scavaenge_gear_sets_3_by_dr_dick.jpg?​direct&​300|}}| |{{:​techtalk:​ih:​oil:​scavaenge_gear_sets_1_by_dr_dick.jpg?​direct&​220|}}|{{:​techtalk:​ih:​oil:​scavaenge_gear_sets_2_by_dr_dick.jpg?​direct&​300|}}|{{:​techtalk:​ih:​oil:​scavaenge_gear_sets_3_by_dr_dick.jpg?​direct&​300|}}|
  
-====== Oil Pump Drive Gears ======+====== ​1957-1967 ​Oil Pump Drive Gear ====== 
 + 
 +The 57-76 pinion shaft has 4 external splines and one is longer than the other three. \\ 
 +The oil pump drive gear has 4 internal splines that match to the pinion shaft with one longer recess between them and is a slip fit over the shaft. \\ 
 +The drive gear slides onto the pinion shaft one way (only) with a timing mark in the front over the wider recess. \\ 
 +You can't install the drive gear in any 360° position where it will fit on the shaft and it's timing mark does not line up with the pinion gear timing mark. \\ 
 +The timing mark on the front of the drive gear isn't used to time anything but may simply be there to distinguish that to be the front of the gear. \\