Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
techtalk:ih:oil03f [2019/06/26 04:51] hippysmack [Check Spring] |
techtalk:ih:oil03f [2019/12/19 04:43] hippysmack [1957-E1962] |
||
---|---|---|---|
Line 6: | Line 6: | ||
* All these use 16t gear sets and style 1 plumbing ((Dr Dick of the XLFORUM http://xlforum.net/forums/showpost.php?p=3272806&postcount=204)) | * All these use 16t gear sets and style 1 plumbing ((Dr Dick of the XLFORUM http://xlforum.net/forums/showpost.php?p=3272806&postcount=204)) | ||
* The production changes made during its run: ((Dr Dick of the XLFORUM http://xlforum.net/forums/showpost.php?p=3272806&postcount=204)) | * The production changes made during its run: ((Dr Dick of the XLFORUM http://xlforum.net/forums/showpost.php?p=3272806&postcount=204)) | ||
- | * 57-e58 baseline pump that all others came from. no oil seal. uses a snap ring and a full profile woodruff key at scavenge gear. | + | * 57-e58 baseline pump that all others came from. \\ No oil seal. \\ Uses a snap ring and a full profile woodruff key at scavenge gear. |
* L58-59 same as above but now has body machined for a oil seal. | * L58-59 same as above but now has body machined for a oil seal. | ||
- | * 60-e62 same as L58-59 but the retaining ring at the scavenge is replaced by half moon retainers. The scavenge drive gear is counter-bored for these half moons and the woodruff key is shortened so it won't interfere with the half moons. | + | * 60-e62 same as L58-59 but the retaining ring at the scavenge is replaced by half moon retainers. \\ The scavenge drive gear is counter-bored for these half moons and the woodruff key is shortened so it won't interfere with the half moons. |
===== L1962-1971 ===== | ===== L1962-1971 ===== | ||
Line 50: | Line 50: | ||
* Wire O.D.: ≈ 0.0250" ((The Doctor71 of the XLFORUM of the XLFORUM http://xlforum.net/forums/showthread.php?t=1661356)) | * Wire O.D.: ≈ 0.0250" ((The Doctor71 of the XLFORUM of the XLFORUM http://xlforum.net/forums/showthread.php?t=1661356)) | ||
+ | This is suppose to be a NOS 67 Pump Spring. \\ | ||
+ | L = 1.215" | ||
+ | Wire Gauge = .024" | ||
|{{:techtalk:ih:oil:1967_oil_pump_spring_by_monte03.jpg?direct&300|}}| | |{{:techtalk:ih:oil:1967_oil_pump_spring_by_monte03.jpg?direct&300|}}| | ||
| 67 oil pump spring. ((photo by Monte03 of the XLFORUM http://xlforum.net/forums/showthread.php?t=823881&page=3))| | | 67 oil pump spring. ((photo by Monte03 of the XLFORUM http://xlforum.net/forums/showthread.php?t=823881&page=3))| |