Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
techtalk:ih:oil03f [2019/12/20 21:55] hippysmack [Check Spring] |
techtalk:ih:oil03f [2020/10/07 02:59] hippysmack [57-76 Oil Pump - Individual Parts and Pics] |
||
|---|---|---|---|
| Line 2: | Line 2: | ||
| ====== IH: Oiling & Lubrication - Sub-03F ====== | ====== IH: Oiling & Lubrication - Sub-03F ====== | ||
| ====== 57-76 Oil Pump - Individual Parts and Pics ====== | ====== 57-76 Oil Pump - Individual Parts and Pics ====== | ||
| + | ===== Sub Documents ===== | ||
| + | * [[techtalk:ref:engmech04k|Breather Valves (1957-Up)]] (list of breather valve changes) | ||
| + | * [[techtalk:ref:engmech07g|Further Study of the Timed Breather Valve]] | ||
| - | ====== Check Ball ====== | + | ====== Oil Check Valve ====== |
| + | |||
| + | The oil pump check valve is in the front of the oil pump> It's a spring and a steel ball set up. \\ | ||
| + | The red area in the pic below is the spring & ball sit. \\ | ||
| + | |||
| + | |||
| + | {{:techtalk:ih:oil:57-76_oil_pump_check_valve_location_by_ironheadjunkie_annotated_by_hippysmack.jpg?direct&300|}} ((photo by ironheadjunkie of the XLFORUM http://xlforum.net/forums/showthread.php?t=1490437)) \\ | ||
| + | |||
| + | |||
| + | ===== Check Ball ===== | ||
| + | See also [[techtalk:ih:oil03g#check_ball_seat_repair|Check ball seat repair]] in the IH Oil Pump section of the Sportsterpedia. \\ | ||
| Used until mid 1958, the tail of check fits inside the hollow center guide bore of the fitting. ((photo by Dr Dick of the XLFORUM http://xlforum.net/forums/showthread.php?t=1347614&page=2)) \\ | Used until mid 1958, the tail of check fits inside the hollow center guide bore of the fitting. ((photo by Dr Dick of the XLFORUM http://xlforum.net/forums/showthread.php?t=1347614&page=2)) \\ | ||
