Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
techtalk:ih:oil04 [2019/03/07 04:19] hippysmack [Connections at the Oil Filter] |
techtalk:ih:oil04 [2019/03/09 00:04] hippysmack [Oil Lines] |
||
---|---|---|---|
Line 31: | Line 31: | ||
The bracket is a piece of .060" sheet metal about 3/4" wide and maybe 3" long with a hole in one end where the bolt passes through it. \\ | The bracket is a piece of .060" sheet metal about 3/4" wide and maybe 3" long with a hole in one end where the bolt passes through it. \\ | ||
The other end is bent in a half circle that fits over the oil line and holds it against the frame / engine. \\ | The other end is bent in a half circle that fits over the oil line and holds it against the frame / engine. \\ | ||
- | | Feed line behind the chain on 73 XLCH ((photo by Rush of the XLFORUM http://xlforum.net/forums/showthread.php?t=80209)) | | + | | Feed line behind the chain on 73 XLCH ((photo by Rush of the XLFORUM http://xlforum.net/forums/showthread.php?t=80209)) | Missing clamp allows the chain to rub the hose. ((photo by Dutch Bobber of the XLFORUM http://xlforum.net/forums/showthread.php?t=2072104&highlight=oil+filter&page=2)) | A steel line was used to replace the rubber hose. ((photo by Dutch Bobber of the XLFORUM http://xlforum.net/forums/showthread.php?t=2072104&highlight=oil+filter&page=2)) | |
- | |{{:techtalk:ih:oil:73_xlch_chain_and_tank_oil_line_by_rush.jpg?direct&300|}}| | + | |{{:techtalk:ih:oil:73_xlch_chain_and_tank_oil_line_by_rush.jpg?direct&300|}}|{{:techtalk:ih:oil:chain_rubbing_oil_line_by_dutch_bobber.jpg?direct&300|}}|{{:techtalk:ih:oil:steel_oil_line_replacement_by_dutch_bobber.jpg?direct&300|}}| |
77-85: \\ | 77-85: \\ |