Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
techtalk:ih:oil04 [2019/06/27 17:19] hippysmack [Sub Documents] |
techtalk:ih:oil04 [2019/06/27 17:51] hippysmack [Sub Documents] |
||
---|---|---|---|
Line 9: | Line 9: | ||
===== Sub Documents ===== | ===== Sub Documents ===== | ||
* [[techtalk:ih:oil04a|Rebuilding the Kidney Tank Oil Cap]] | * [[techtalk:ih:oil04a|Rebuilding the Kidney Tank Oil Cap]] | ||
+ | \\ | ||
+ | There have been negative comments about in-tank oil filters in the past, but these all refer to an old, original "horse hair" filter. ((IronMick of the XLFORUM http://xlforum.net/forums/showthread.php?t=2072162)) \\ | ||
+ | The modern replacements are very good indeed. \\ | ||
+ | But you'll need to shorten your dipstick to use the newer in-tank filters unless you find a "Horsehair" type. ((Popgadget of the XLFORUM http://xlforum.net/forums/showthread.php?t=2072162)) \\ | ||
+ | The newer pleated paper ones are a better choice though. \\ | ||
+ | See the example below of shortening the dipstick. \\ | ||
| Uncut dipstick. ((IronMick of the XLFORUM http://xlforum.net/forums/showthread.php?t=2072162)) | After cutting. ((IronMick of the XLFORUM http://xlforum.net/forums/showthread.php?t=2072162)) | Roll pin goes thru the "top" (smaller) hole. ((IronMick of the XLFORUM http://xlforum.net/forums/showthread.php?t=2072162)) | | | Uncut dipstick. ((IronMick of the XLFORUM http://xlforum.net/forums/showthread.php?t=2072162)) | After cutting. ((IronMick of the XLFORUM http://xlforum.net/forums/showthread.php?t=2072162)) | Roll pin goes thru the "top" (smaller) hole. ((IronMick of the XLFORUM http://xlforum.net/forums/showthread.php?t=2072162)) | |