Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
techtalk:ih:oil06 [2021/02/18 04:35] hippysmack [Transmission Vent Hose (77-85)] |
techtalk:ih:oil06 [2021/02/19 21:59] hippysmack [Transmission Vent Hose (77-85)] |
||
---|---|---|---|
Line 622: | Line 622: | ||
Blow on the hose end to make sure you can push air thru it. Do not used compressed air as that can damage the sprocket shaft seal. \\ | Blow on the hose end to make sure you can push air thru it. Do not used compressed air as that can damage the sprocket shaft seal. \\ | ||
Reroute the hose if it is showing a kink in placement or replace it if you can't blow through it. \\ | Reroute the hose if it is showing a kink in placement or replace it if you can't blow through it. \\ | ||
- | You can also take of the primary chain inspection cap and blow air into the primary compartment. \\ | + | You can also take off the primary chain inspection cap and blow air into the primary compartment. \\ |
You should hear and feel the air come out of the inspection hole and with the cap off, you are not pressurizing anything too much. ((IronMick of the XLFORUM http://xlforum.net/forums/showthread.php?t=944018&page=2)) \\ | You should hear and feel the air come out of the inspection hole and with the cap off, you are not pressurizing anything too much. ((IronMick of the XLFORUM http://xlforum.net/forums/showthread.php?t=944018&page=2)) \\ | ||
There should be no sags in the hose between the attachment to the engine and the open end of the hose. \\ | There should be no sags in the hose between the attachment to the engine and the open end of the hose. \\ |