Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
techtalk:ih:priclutch02 [2018/03/11 02:17] ixl2relax ↷ Links adapted because of a move operation |
techtalk:ih:priclutch02 [2022/01/17 00:25] hippysmack [Engine Sprocket] |
||
|---|---|---|---|
| Line 9: | Line 9: | ||
| |{{techtalk:ih:priclutch:77_xlh_w_86-90_chain_spring_tensioner_by_northern_bobber.jpg?direct&300|}}| | |{{techtalk:ih:priclutch:77_xlh_w_86-90_chain_spring_tensioner_by_northern_bobber.jpg?direct&300|}}| | ||
| - | | 77 XLH with 86-90 Primary Chain \\ Tensioner & Spring (40019-86) ((photo by northern bobber of the XLFORUM http://xlforum.net/vbportal/forums/showthread.php?t=1980020&page=3)) | | + | | 77 XLH with 86-90 Primary Chain \\ Tensioner & Spring (40019-86) ((photo by northern bobber of the XLFORUM http://xlforum.net/forums/showthread.php?t=1980020&page=3)) | |
| + | ====== Primary Fill / Drain Holes ====== | ||
| + | ====== Engine Sprocket ====== | ||
| + | 1957-1966 XLH, 1958-1969 XLCH sprocket kick only (40288-58) has the rear mounting surface below face. \\ | ||
| + | 1967-1976 XLH, 1970-1976 XLCH sprocket (40235-70A) has a mounting surface protruding from the face. \\ | ||
| + | 1977-up (all) sprocket (40235-74) has a mounting surface protruding even farther with a larger seal diameter. \\ | ||
| + | Noe of them are marked with part#s. ((mct496 of the XLFORUM http://xlforum.net/forums/showthread.php?p=4325723#post4325723)) \\ | ||
| \\ | \\ | ||
| [[:techtalk:menu|{{:techtalk:gototechnicalmenu.jpg|}}]] | [[:techtalk:menu|{{:techtalk:gototechnicalmenu.jpg|}}]] | ||
