Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
techtalk:ih:wheels02 [2018/01/10 02:28] hippysmack [Right Side Bearing Spacer Washer (between the bearings)] |
techtalk:ih:wheels02 [2019/02/15 11:47] hippysmack [Brake Pedal Stop] |
||
---|---|---|---|
Line 46: | Line 46: | ||
* When proper free play is achieved , apply Harley Davidson Lock 'N Seal (99625-77) to the threads and then tighten the jamnut to 12-15 ft-lbs. while holding the screw in position. | * When proper free play is achieved , apply Harley Davidson Lock 'N Seal (99625-77) to the threads and then tighten the jamnut to 12-15 ft-lbs. while holding the screw in position. | ||
* When properly adjusted, the brake pedal should be parallel to the ground when bottomed against brake pedal stop. | * When properly adjusted, the brake pedal should be parallel to the ground when bottomed against brake pedal stop. | ||
+ | |||
+ | ====== Rear Brake Pedal Stop ====== | ||
+ | * . . . [[techtalk:ih:wheels02b|Fabricating a Brake Pedal Stop]] | ||
- | ---- | ||