Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
techtalk:ih:wheels02 [2018/01/10 02:28] hippysmack [Right Side Bearing Spacer Washer (between the bearings)] |
techtalk:ih:wheels02 [2020/04/11 21:35] hippysmack [Brake System] |
||
|---|---|---|---|
| Line 3: | Line 3: | ||
| ====== Brake System ====== | ====== Brake System ====== | ||
| + | See also [[techtalk:ref:wheels06#bleeding_the_brake_lines|Bleeding the Brake Lines]] In the REF section of the Sportsterpedia. \\ | ||
| ====== Drum Braking System ====== | ====== Drum Braking System ====== | ||
| Line 46: | Line 47: | ||
| * When proper free play is achieved , apply Harley Davidson Lock 'N Seal (99625-77) to the threads and then tighten the jamnut to 12-15 ft-lbs. while holding the screw in position. | * When proper free play is achieved , apply Harley Davidson Lock 'N Seal (99625-77) to the threads and then tighten the jamnut to 12-15 ft-lbs. while holding the screw in position. | ||
| * When properly adjusted, the brake pedal should be parallel to the ground when bottomed against brake pedal stop. | * When properly adjusted, the brake pedal should be parallel to the ground when bottomed against brake pedal stop. | ||
| + | |||
| + | ====== Rear Brake Pedal Stop ====== | ||
| + | * . . . [[techtalk:ih:wheels02b|Fabricating a Brake Pedal Stop]] | ||
| - | ---- | ||
