Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Last revision Both sides next revision | ||
|
techtalk:ref:body20 [2018/11/07 22:50] hippysmack [Riser Mods] |
techtalk:ref:body20 [2022/03/09 05:15] ixl2relax ↷ Page name changed from techtalk:ref:body12 to techtalk:ref:body20 |
||
|---|---|---|---|
| Line 3: | Line 3: | ||
| ====== Aftermarket Handlebars, Risers and Mods ====== | ====== Aftermarket Handlebars, Risers and Mods ====== | ||
| + | |||
| ====== Handlebars ====== | ====== Handlebars ====== | ||
| + | |||
| + | * Harley-Davidson has a downloadable PDF catalog of various handlebar options, recently updated in 2020 - https://serviceinfo.harley-davidson.com/sip/service/document/original/1420463678980971765/2020_sep_24_hbars.pdf | ||
| + | |||
| * For those who are shopping around for different types of bars (with their measurements), this section will show an approximate view from the seat and the side of how the different bars look while installed. Looks can be deceiving however with different models, color backgrounds and perceptions. | * For those who are shopping around for different types of bars (with their measurements), this section will show an approximate view from the seat and the side of how the different bars look while installed. Looks can be deceiving however with different models, color backgrounds and perceptions. | ||
| | | ||
| Line 24: | Line 28: | ||
| ==== Offset Riser Blocks ==== | ==== Offset Riser Blocks ==== | ||
| + | {{:techtalk:ref:body:offset_riser_mod_7_by_tobiism.jpg?direct&300|}} ((photo by tobiism of the XLFORUM http://xlforum.net/forums/showthread.php?t=906049&page=23)) | ||
| + | |||
| |Start with some square stock aluminum, drill holes for the bars (7/8" / 1" etc.) and mark center on the outside edge to cut a pinch slot. ((photos by tobiism of the XLFORUM http://xlforum.net/forums/showthread.php?t=906049&page=22))||| | |Start with some square stock aluminum, drill holes for the bars (7/8" / 1" etc.) and mark center on the outside edge to cut a pinch slot. ((photos by tobiism of the XLFORUM http://xlforum.net/forums/showthread.php?t=906049&page=22))||| | ||
| |{{:techtalk:ref:body:offset_riser_mod_1_by_tobiism.jpg?direct&300|}}|{{:techtalk:ref:body:offset_riser_mod_2_by_tobiism.jpg?direct&300|}}|{{:techtalk:ref:body:offset_riser_mod_3_by_tobiism.jpg?direct&300|}}| | |{{:techtalk:ref:body:offset_riser_mod_1_by_tobiism.jpg?direct&300|}}|{{:techtalk:ref:body:offset_riser_mod_2_by_tobiism.jpg?direct&300|}}|{{:techtalk:ref:body:offset_riser_mod_3_by_tobiism.jpg?direct&300|}}| | ||
