Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
techtalk:ref:carb07 [2019/08/18 19:13] hippysmack [Replacing the Plastic Fuel Inlet Fitting with a Brass 90 Degree Fitting] |
techtalk:ref:carb07 [2019/08/18 20:34] hippysmack [The Process] |
||
---|---|---|---|
Line 113: | Line 113: | ||
Once the piece begins to move it will pull out like butter. ((photos by Hippysmack)) \\ | Once the piece begins to move it will pull out like butter. ((photos by Hippysmack)) \\ | ||
Once the nipple is out, you may have to 'pop' the spacer of as it may wedge against the carb. \\ | Once the nipple is out, you may have to 'pop' the spacer of as it may wedge against the carb. \\ | ||
+ | |||
+ | A socket may be used as a spacer with the appropriate length bolt. \\ | ||
+ | {{:techtalk:ref:carb:socket_as_spacer_for_removing_cv_carb_inlet_by_matt_black.jpg?direct&300|}} ((photo by Matt Black of the XLFORUM http://xlforum.net/forums/showthread.php?p=5685578&highlight=fuel+inlet+elbow#post5685578)) \\ | ||
{{:techtalk:ref:carb:cv_fuel_inlet_elbow_mod_17_by_hippysmack.jpg?direct&300|}} {{:techtalk:ref:carb:cv_fuel_inlet_elbow_mod_18_by_hippysmack.jpg?direct&300|}} {{:techtalk:ref:carb:cv_fuel_inlet_elbow_mod_19_by_hippysmack.jpg?direct&300|}} | {{:techtalk:ref:carb:cv_fuel_inlet_elbow_mod_17_by_hippysmack.jpg?direct&300|}} {{:techtalk:ref:carb:cv_fuel_inlet_elbow_mod_18_by_hippysmack.jpg?direct&300|}} {{:techtalk:ref:carb:cv_fuel_inlet_elbow_mod_19_by_hippysmack.jpg?direct&300|}} |