Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
techtalk:ref:carb07 [2019/08/18 19:12] hippysmack [Replacing the Plastic Fuel Inlet Fitting] |
techtalk:ref:carb07 [2019/08/18 19:13] hippysmack [Replacing the Plastic Fuel Inlet Fitting with a Brass 90 Degree Fitting] |
||
|---|---|---|---|
| Line 8: | Line 8: | ||
| The plastic attached to the brass nipple can crack or break off when removing the original crimp clamp or if over tightened. \\ | The plastic attached to the brass nipple can crack or break off when removing the original crimp clamp or if over tightened. \\ | ||
| Stress can also break it while removing / installing the carb if the attached hose gets caught on something and pulled. \\ | Stress can also break it while removing / installing the carb if the attached hose gets caught on something and pulled. \\ | ||
| - | Replacing the factory elbow with a brass one will increase gas flow (especially with a vacuum-less petcock). \\ | + | Replacing the factory elbow with a brass one can increase gas flow (especially with a vacuum-less petcock). \\ |
| | Factory plastic fuel inlet elbow. ((photo by Hippysmack)) | | | Factory plastic fuel inlet elbow. ((photo by Hippysmack)) | | ||
| |{{:techtalk:ref:carb:cv_fuel_inlet_elbow_mod_7_by_hippysmack.jpg?direct&300|}}| | |{{:techtalk:ref:carb:cv_fuel_inlet_elbow_mod_7_by_hippysmack.jpg?direct&300|}}| | ||
