Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
techtalk:ref:carb07 [2019/10/14 23:58] hippysmack |
techtalk:ref:carb07 [2019/10/15 00:00] hippysmack [EZ-Just Mixture Screws] |
||
---|---|---|---|
Line 22: | Line 22: | ||
Then pry the plug out using a pick or you could twist a small sheet metal screw into the hole to pull the plug out. \\ | Then pry the plug out using a pick or you could twist a small sheet metal screw into the hole to pull the plug out. \\ | ||
With the plug removed clean the area around the mixture screw so no metal fragments remain. \\ | With the plug removed clean the area around the mixture screw so no metal fragments remain. \\ | ||
- | {{techtalk:evo:carb:cv40-imscap-drillbit.jpg?300|}} ((photo by cantolina of the XLFORUM http://xlforum.net/forums/showthread.php?t=14949)) Circled area is where you drill out the plug. {{:techtalk:ref:carb:idle_mixture_screw_location_by_popgadget-_annotated.jpg?direct&300|}} ((photo by popgadget of the XLFORUM, annotated by Hippysmack)) \\ | + | {{techtalk:evo:carb:cv40-imscap-drillbit.jpg?300|}} ((photo by cantolina of the XLFORUM http://xlforum.net/forums/showthread.php?t=14949)) Circled area is where you drill out the plug. {{:techtalk:ref:carb:cv_carb_bottom_by_cantolina.jpg?direct&300|}} ((photo by cantolina of the XLFORUM http://xlforum.net/forums/showthread.php?t=14949)) |
The EZ-Just mixture screw must be threaded in completely (lightly seated) prior to backing out and making final adjustments. \\ | The EZ-Just mixture screw must be threaded in completely (lightly seated) prior to backing out and making final adjustments. \\ |