Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
techtalk:ref:carb07 [2019/10/15 00:24]
hippysmack [Adjustable Main Jet (L76-87)]
techtalk:ref:carb07 [2019/10/15 03:24] (current)
hippysmack [Velocity Stack]
Line 94: Line 94:
 It requires a total of 2 gaskets (included) to install. ((photos by Hippysmack)) \\ It requires a total of 2 gaskets (included) to install. ((photos by Hippysmack)) \\
  
 +This is a "​V-Ductor"​ from CV Performance. ((https://​cv-performance.com/​v-ductor-installation)) \\
 |{{:​techtalk:​ref:​carb:​velocity_stack_1_by_hippysmack.jpg?​direct&​300|}}|{{:​techtalk:​ref:​carb:​velocity_stack_2_by_hippysmack.jpg?​direct&​300|}}| |{{:​techtalk:​ref:​carb:​velocity_stack_1_by_hippysmack.jpg?​direct&​300|}}|{{:​techtalk:​ref:​carb:​velocity_stack_2_by_hippysmack.jpg?​direct&​300|}}|
 +
 +  * Remove the air cleaner backing plate.
 +  * Place a gasket onto the backing plate, then the V-Ductor and another gasket (2 supplied in the kit).
 +  * The smaller end of the cone faces into the carb.
 +  * Install the new assembly onto the carb and torque to factory specs.
 +  * backing plate with as normal against the V-Ductor. Installation of your air box will vary depending upon the 
  
 |{{:​techtalk:​ref:​carb:​velocity_stack_3_by_hippysmack.jpg?​direct&​300|}}|{{:​techtalk:​ref:​carb:​velocity_stack_4_by_hippysmack.jpg?​direct&​300|}}|{{:​techtalk:​ref:​carb:​velocity_stack_5_by_hippysmack.jpg?​direct&​300|}}| |{{:​techtalk:​ref:​carb:​velocity_stack_3_by_hippysmack.jpg?​direct&​300|}}|{{:​techtalk:​ref:​carb:​velocity_stack_4_by_hippysmack.jpg?​direct&​300|}}|{{:​techtalk:​ref:​carb:​velocity_stack_5_by_hippysmack.jpg?​direct&​300|}}|