Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
techtalk:ref:elec17 [2020/09/02 20:54] ixl2relax [Replacing A Key Switch] |
techtalk:ref:elec17 [2020/09/02 21:07] ixl2relax [Replacing A Key Switch] |
||
|---|---|---|---|
| Line 11: | Line 11: | ||
| ===== Replacing A Key Switch ===== | ===== Replacing A Key Switch ===== | ||
| - | Check the Electrical Section of IH or EVO for the OEM configuration of the Keyswitch. | + | Check the Electrical Section of [[techtalk:ih:elec03|IH]] or [[techtalk:evo:elec03|EVO]] for the OEM configuration of the Keyswitch. |
| + | If you have to replace a keyswitch, realize that the 3-position keyswitches that are commonly available\\ | ||
| + | have the same internal operations but there are two different ways they are labelled: | ||
| + | |||
| + | {{:techtalk:ref:elec:keyswitch-3pos-old-new.jpg?400|}}((Illustration by IXL2Relax)) | ||
| + | |||
| + | If you buy an older style switch (with B - IG - L functions) realize that you can use that switch\\ | ||
| + | on the later models, but the labels will not be correct for how you must connect it. | ||
| + | |||
| + | If using the early switch on a later model, you will connect the wires as follows: | ||
| + | |||
| + | ^ Using Older Style 3-position Keyswitch on Newer Style Wiring ||| | ||
| + | ^ Switch Label ^ Connection From/To ^ Typical Wire Color | | ||
| + | | B | FROM Main Circuit Breaker | RED wire | | ||
| + | | IG | TO Accessory Fuse Only | RED/Gray wire | | ||
| + | | L | TO All Other Fuses | RED/Black wire | | ||
