Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
techtalk:ref:elec18 [2020/01/14 05:08] ixl2relax [HD Sportster Fuel Gauge Kit] |
techtalk:ref:elec18 [2020/01/14 05:15] ixl2relax [HD Sportster Fuel Gauge Kit] |
||
|---|---|---|---|
| Line 57: | Line 57: | ||
| 75338-09 - Sportster Fuel Gauge Kit - Chrome\\ | 75338-09 - Sportster Fuel Gauge Kit - Chrome\\ | ||
| - | {{:techtalk:ref:elec:fuel-auge-xl-mastcylcap-75338-09-chrome.jpg?300|}} | + | {{:techtalk:ref:elec:fuel-gauge-xl-mastcylcap-75338-09-chrome.jpg?300|}} |
| - | This kit fits '07-later XL and replaces the master cylinder cover on the right hand controls. It provides four levels of fuel from FULL to LOW, with the bars going dark. The lowest indicator will be lit near the same time as the Speedometer low-fuel indicator. When the sensor cannot detect a fuel level, the lowest indicator will begin to flash. Note that the Fuel Pump Icon will remain lit whenever power is on and is not part of the level indication. | + | This kit fits '07-later XL and replaces the master cylinder cover on the right hand controls. It provides four levels of fuel from FULL to LOW, with the bars going dark. The lowest indicator will be lit near the same time as the Speedometer low-fuel indicator. When the sensor cannot detect a fuel level, the lowest indicator will begin to flash. Note that the Fuel Pump Icon will remain lit whenever power is on and is not part of the level indication. During the installation of the gauge, the Fuel Sender Resistor Assy is removed and the gauge wiring is plugged into Connector 200B instead of the Resistor Assy. |
| - | This kit uses fuel gauge sensor 75093-09, which uses capacitive-sensing technology to detect the fuel level. The Fuel Sender Resistor Assy is removed and this sensor is connected to Connector 200B instead of it. | + | This kit uses fuel gauge sensor 75093-09, which uses capacitive-sensing technology to detect the fuel level. |
| For 2007 models (only) - After the sensor is installed & connected to the gauge, the motorcyle must be taken to a dealer to have a software update installed by the dealer's DTII programming before the gauge will operate properly. The low-fuel light will stay on until the update is installed. | For 2007 models (only) - After the sensor is installed & connected to the gauge, the motorcyle must be taken to a dealer to have a software update installed by the dealer's DTII programming before the gauge will operate properly. The low-fuel light will stay on until the update is installed. | ||
