This is an old revision of the document!

REF: Electrical System

Turn Signal Mods / Relocating

Article by vwclogan of the XLFORUM ¹⁾

Turns on 07 XL1200N relocated to the lower trees ²⁾

Tools include a hacksaw, file and a drill. ³⁾	1/2“ OD pipe cut down for spacers. ⁴⁾

Template for the bracket. Entire drawing should print out 2” x 2“. (notched to get around a small edge in the tree) ⁵⁾	Holes drilled in 3/4” wide bracket. Left hole (tree) - 3/8“. Right hole (turn) 5/16”. ⁶⁾

Parts: (2) 5/16“x24x1-1/2” bolt, lockwashers and spacers. ⁷⁾

Remove the lower tree bolt on the right side. ⁸⁾	Remove the rounded bolt from the signal with an Allen wrench. ⁹⁾

Bolt the new bracket to the tree. ¹⁰⁾		Add a spacer on a bolt to extend the turn housing. ¹¹⁾

Tighten the turn and zip tie the wires nice and neat. ¹²⁾		Reposition as needed and start on the other side. ¹³⁾

After / Before
Stock front turns on an 07 XL1200N ¹⁴⁾

¹⁾

²⁾ , ⁵⁾ , ⁹⁾ , ¹¹⁾ , ¹³⁾ , ¹⁴⁾

³⁾ , ⁴⁾ , ⁶⁾

⁷⁾

⁸⁾

photo by vwclogan of the XLFORUM, resized/cropped by Hippysmack http://xlforum.net/forums/showthread.php?t=916453&page=2

¹⁰⁾

¹²⁾

photos by vwclogan of the XLFORUM, resized/cropped by Hippysmack http://xlforum.net/forums/showthread.php?t=916453&page=2

Trace: