This is an old revision of the document!


REF: Electrical System

Turn Signal Mods / Relocating

Front Turns on the Trees

The vwclogan Front Turn Signal Mod

2007 XL1200N 1)
Tools include a hacksaw, file and a drill. 2)1/4“ steel tubing, black 1/4” PVC tubing or a
bunch of washers can used for spacers. 3) 4)
Template for the bracket.
Entire drawing should print out 2“ x 2”.
(notched to get around a small edge in the tree) 5)
Holes drilled in 3/4“ wide bracket.
Left hole (tree) - 3/8”. Right hole (turn) 5/16“. 6)
Parts: (2) 5/16”x24x1-1/2“ bolt, lockwashers and spacers. 7)
Remove the lower tree bolt on the right side. 8)Remove the rounded bolt from the signal with an
Allen wrench. 9)
Mount the new bracket to the tree. Torque the existing bolt (#45 Torx socket head) to 30-35 ft lbs. 10) 11)Add a spacer on a bolt to extend the turn housing. 12)
Tighten the turn and zip tie the wires nice and neat. 13)Reposition as needed and start on the other side. 14)
After / Before
Stock front turns on a 2007 XL1200N 15)

Alternate Bracket Material

Use the original signal mounts, some flat metal stock and a bolt with the same thread as mirrors. Cut the stock to size and drill the 3/8” holes for the tree mount. 16)

Bikes with this mod

Mounted to lower trees:

2012 883N 17) 2009 XL1200N 18) 2007 883L 19)

Mounted to upper trees:

2000 XL1200 20)

Front Turns on the Forks

98 1200C
Turns mounted with electrical conduit clamps. 21)
09 883L
Turns mounted with electrical conduit clamps. 22)

Rear Turns


This website uses cookies for visitor traffic analysis. By using the website, you agree with storing the cookies on your computer.More information