Differences
This shows you the differences between two versions of the page.
|
techtalk:ref:engmech01g [2018/07/17 22:43] hippysmack created |
techtalk:ref:engmech01g [2018/07/17 22:45] (current) hippysmack |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| [[:techtalk:menu|{{ :techtalk:gototechnicalmenu.jpg|}}]] | [[:techtalk:menu|{{ :techtalk:gototechnicalmenu.jpg|}}]] | ||
| ====== REF: Engine Mechanicals - Sub-01G ====== | ====== REF: Engine Mechanicals - Sub-01G ====== | ||
| + | ====== Cam Bushing Removal ====== | ||
| + | * You can buy different brands but this is basically a slide hammer with an expandable collet. | ||
| + | |||
| + | | Blind Hole Bearing Puller (Harbor Freight model) ((photo by Hippysmack)) | | ||
| + | |{{:techtalk:ref:tools:98_1200_cam_bushing_removal_2_by_hippysmack.jpg?direct&300|}}| | ||
| + | |||
| + | | Decrease the width of the collet ((photo by Hippysmack)) | Install it into and behind the bushing ((photo by Hippysmack)) | Tighten the nuts to expand the collet ((photo by Hippysmack)) | | ||
| + | |{{:techtalk:ref:engmech:98_1200_cam_bushing_removal_3_by_hippysmack.jpg?direct&300|}}|{{:techtalk:ref:engmech:98_1200_cam_bushing_removal_4_by_hippysmack.jpg?direct&300|}}|{{:techtalk:ref:engmech:98_1200_cam_bushing_removal_5_by_hippysmack.jpg?direct&300|}}| | ||
| + | |||
| + | | Hold outward pressure on the handle. Then yank the bushings out by knocking the slide against the handle end of the tool ((photos by Hippysmack)) ||| | ||
| + | |{{:techtalk:ref:engmech:98_1200_cam_bushing_removal_6_by_hippysmack.jpg?direct&300|}}|{{techtalk:ref:tools:cam_bushing_installer_2_by_hippysmack.jpg?direct&300|}}|{{techtalk:ref:tools:cam_bushing_installer_1_by_hippysmack.jpg?direct&300|}}| | ||
| + | |||
| + | |The collet isn't wide enough to damage the case on \\ the way out ((photo by Hippysmack))|However, the chamfer inside the collet will damage \\ the bushing (L). Compare to new bushing on the right. ((photo by Hippysmack))| | ||
| + | |{{:techtalk:ref:engmech:98_1200_cam_bushing_removal_7_by_hippysmack.jpg?direct&300|}}|{{:techtalk:ref:engmech:98_1200_cam_bushing_removal_8_by_hippysmack.jpg?direct&300|}}| | ||
