Differences
This shows you the differences between two versions of the page.
Next revision Both sides next revision | |||
techtalk:ref:engmech01h [2018/07/25 21:35] hippysmack created |
techtalk:ref:engmech01h [2018/09/19 03:10] hippysmack [Test Fitting Cams] |
||
---|---|---|---|
Line 3: | Line 3: | ||
====== Test Fitting Cams ====== | ====== Test Fitting Cams ====== | ||
- | Install all 4 cams in the gearcase with the pinion gear removed. \\ Use a fair amount of assembly lube in the bushings and in the gear teeth. | + | Install all 4 cams in the gearcase with the pinion gear removed. \\ |
+ | Use a fair amount of assembly lube in the bushings and in the gear teeth. \\ | ||
+ | Rotate them by hand and make sure they all spin freely without binding. \\ | ||
Then, install all 4 cams in the cam cover and make sure they spin freely without binding. | Then, install all 4 cams in the cam cover and make sure they spin freely without binding. | ||
Line 9: | Line 11: | ||
|{{:techtalk:ref:engmech:test_fit_cams_in_cam_cover_by_aswracing.jpg?direct&300|}}| | |{{:techtalk:ref:engmech:test_fit_cams_in_cam_cover_by_aswracing.jpg?direct&300|}}| | ||
| Test fitting cams in the cam cover ((photo by aswracing of the XLFORUM http://xlforum.net/forums/showthread.php?t=1715966&page=3)) | | | Test fitting cams in the cam cover ((photo by aswracing of the XLFORUM http://xlforum.net/forums/showthread.php?t=1715966&page=3)) | | ||
+ | |||
+ | |{{:techtalk:ref:engmech:test_fitting_cams_with_the_cam_cover_on_by_aswracing.jpg?direct&300|}}| | ||
+ | |Test fitting cams with the cam cover installed ((photo by aswracing of the XLFORUM http://xlforum.net/forums/showthread.php?t=1840595))| | ||
+ | |||
\\ | \\ |