Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
techtalk:ref:engmech01h [2018/09/19 03:18] hippysmack [Test Fitting Cams] |
techtalk:ref:engmech01h [2019/08/16 12:43] hippysmack [Test Fitting Cams] |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| [[:techtalk:menu|{{ :techtalk:gototechnicalmenu.jpg|}}]] | [[:techtalk:menu|{{ :techtalk:gototechnicalmenu.jpg|}}]] | ||
| ====== REF: Engine Mechanicals - Sub-01H ====== | ====== REF: Engine Mechanicals - Sub-01H ====== | ||
| - | ====== Test Fitting Cams ====== | + | ====== Clearancing for and Test Fitting Cams ====== |
| - | Factory fitting of the cams is (or rather was) all about noise control. \\ | + | |
| + | ====== Clearancing ====== | ||
| + | |||
| + | ====== Test Fitting ====== | ||
| + | Factory fitting of the cams is (or rather was) all about noise control. ((aswracing of the XLFORUM http://xlforum.net/forums/showthread.php?t=1840595)) \\ | ||
| By selecting the cam gears sized specifically for the engine they were going in, they could walk that fine line between noisy and too-tight. \\ | By selecting the cam gears sized specifically for the engine they were going in, they could walk that fine line between noisy and too-tight. \\ | ||
| The noise from the gears being a tad loose doesn't hurt anything. Too-tight however can cause localized tooth heating and failure. \\ | The noise from the gears being a tad loose doesn't hurt anything. Too-tight however can cause localized tooth heating and failure. \\ | ||
