Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
techtalk:ref:engmech02f [2019/04/12 04:59] hippysmack [Installing Hammer Performance Billet Pushrod Base Kit] |
techtalk:ref:engmech02f [2019/04/12 05:07] hippysmack [Installing Hammer Performance Billet Pushrod Base Kit] |
||
---|---|---|---|
Line 64: | Line 64: | ||
|{{:techtalk:ref:engmech:hammerperf_pushrod_bases_17_by_hippysmack.jpg?direct&300|}}|{{:techtalk:ref:engmech:hammerperf_pushrod_bases_18_by_hippysmack.jpg?direct&300|}}| | |{{:techtalk:ref:engmech:hammerperf_pushrod_bases_17_by_hippysmack.jpg?direct&300|}}|{{:techtalk:ref:engmech:hammerperf_pushrod_bases_18_by_hippysmack.jpg?direct&300|}}| | ||
- | |Swing them in and center the tubes over the lifter bore. Stop short of all the way down and make sure the seals are still in place all around the base. ((photos by Hippysmack))||| | + | |Swing them in and center the tubes over the lifter bore. Stop short of all the way down and make sure the seals are still in place all around the base. \\ Due to angles of the tubes and the way you pulled the base down, the seal(s) may be a little uneven. Just make sure the seals are inside the base at this point. ((photos by Hippysmack))||| |
|{{:techtalk:ref:engmech:hammerperf_pushrod_bases_19_by_hippysmack.jpg?direct&300|}}|{{:techtalk:ref:engmech:hammerperf_pushrod_bases_20_by_hippysmack.jpg?direct&300|}}|{{:techtalk:ref:engmech:hammerperf_pushrod_bases_21_by_hippysmack.jpg?direct&300|}}| | |{{:techtalk:ref:engmech:hammerperf_pushrod_bases_19_by_hippysmack.jpg?direct&300|}}|{{:techtalk:ref:engmech:hammerperf_pushrod_bases_20_by_hippysmack.jpg?direct&300|}}|{{:techtalk:ref:engmech:hammerperf_pushrod_bases_21_by_hippysmack.jpg?direct&300|}}| | ||