Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision 		Previous revision
Next revision Both sides next revision
techtalk:ref:engmech02f [2019/04/12 05:07]
hippysmack [Installing Hammer Performance Billet Pushrod Base Kit] 		techtalk:ref:engmech02f [2019/08/04 01:39]
hippysmack [Installing Hammer Performance Billet Pushrod Base Kit]
Line 66: Line 66:
 |Swing them in and center the tubes over the lifter bore. Stop short of all the way down and make sure the seals are still in place all around the base. \\ Due to angles of the tubes and the way you pulled the base down, the seal(s) may be a little uneven. Just make sure the seals are inside the base at this point. ​ ((photos by Hippysmack))||| |Swing them in and center the tubes over the lifter bore. Stop short of all the way down and make sure the seals are still in place all around the base. \\ Due to angles of the tubes and the way you pulled the base down, the seal(s) may be a little uneven. Just make sure the seals are inside the base at this point. ​ ((photos by Hippysmack))|||
 |{{:​techtalk:​ref:​engmech:​hammerperf_pushrod_bases_19_by_hippysmack.jpg?​direct&​300|}}|{{:​techtalk:​ref:​engmech:​hammerperf_pushrod_bases_20_by_hippysmack.jpg?​direct&​300|}}|{{:​techtalk:​ref:​engmech:​hammerperf_pushrod_bases_21_by_hippysmack.jpg?​direct&​300|}}| |{{:​techtalk:​ref:​engmech:​hammerperf_pushrod_bases_19_by_hippysmack.jpg?​direct&​300|}}|{{:​techtalk:​ref:​engmech:​hammerperf_pushrod_bases_20_by_hippysmack.jpg?​direct&​300|}}|{{:​techtalk:​ref:​engmech:​hammerperf_pushrod_bases_21_by_hippysmack.jpg?​direct&​300|}}|
 +
 +**Check the clearance between the tubes and cylinder fins before installing the bolts**. \\
 +On big cylinders, you may have to grind some off the fins to get a good fit between them.
 +
 +|  (R) (fins 90" jugs had to be ground for tube clearance) (F) ((photos by DonChicago48 of the XLFORUM http://​xlforum.net/​forums/​showthread.php?​t=1610587&​page=21)) ​ ||
 +|{{:​techtalk:​ref:​engmech:​hammerperf_rear_pushrod_tube_clearance_issue_by_donchicago48.jpg?​direct&​300|}}|{{:​techtalk:​ref:​engmech:​hammerperf_front_pushrod_tube_clearance_issue_by_donchicago48.jpg?​direct&​300|}}|
 +
 +
 +
  
   * Push the base down onto the case deck and hold pressure on the base with one hand.   * Push the base down onto the case deck and hold pressure on the base with one hand.

Trace: