Differences

This shows you the differences between two versions of the page.

--- techtalk:ref:engmech02f [2019/06/12 04:01]
hippysmack [Installing Hammer Performance Billet Pushrod Base Kit]
+++ techtalk:ref:engmech02f [2019/08/04 01:39]
hippysmack [Installing Hammer Performance Billet Pushrod Base Kit]
@@ Line 67: / Line 67: @@
 |{{:techtalk:ref:engmech:hammerperf_pushrod_bases_19_by_hippysmack.jpg?direct&300|}}|{{:techtalk:ref:engmech:hammerperf_pushrod_bases_20_by_hippysmack.jpg?direct&300|}}|{{:techtalk:ref:engmech:hammerperf_pushrod_bases_21_by_hippysmack.jpg?direct&300|}}|
-  * Check the clearance between the tubes and cylinder fins before installing the bolts. \\ On big cylinders, you may have to grind some off the fins to get a good fit between them.
+**Check the clearance between the tubes and cylinder fins before installing the bolts**. \\
+On big cylinders, you may have to grind some off the fins to get a good fit between them.
 |  (R) (fins 90" jugs had to be ground for tube clearance) (F) ((photos by DonChicago48 of the XLFORUM http://xlforum.net/forums/showthread.php?t=1610587&page=21))  ||
 |{{:techtalk:ref:engmech:hammerperf_rear_pushrod_tube_clearance_issue_by_donchicago48.jpg?direct&300|}}|{{:techtalk:ref:engmech:hammerperf_front_pushrod_tube_clearance_issue_by_donchicago48.jpg?direct&300|}}|
   * Push the base down onto the case deck and hold pressure on the base with one hand.

Trace: