Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
techtalk:ref:engmech05 [2020/03/02 20:03] hippysmack [Sub Documents] |
techtalk:ref:engmech05 [2020/03/02 20:28] hippysmack [Homemade Breather Valves] |
||
---|---|---|---|
Line 217: | Line 217: | ||
|{{:techtalk:ref:engmech:mercedes_benz_pcv_valve_by_electronbee.jpg?direct&300|}}| | |{{:techtalk:ref:engmech:mercedes_benz_pcv_valve_by_electronbee.jpg?direct&300|}}| | ||
+ | ====== Homemade Breather Valves ====== | ||
+ | This was made by norseXL of the XLFORUM ((http://xlforum.net/forums/showthread.php?p=5809352#post5809352)) \\ | ||
+ | A male threaded cap was made to screw into the female threaded body of the breather valve container as shown below. \\ | ||
+ | The center of the cap was drilled and tapped for a hollow (5.5mm) M10 bolt. \\ | ||
+ | The cam cover was also drilled and tapped for M10 threads. \\ | ||
+ | The brass adapter for the banjo also has M10 internal threads. \\ | ||
+ | The umbrella inside the body is the stock 91-03 umbrella. \\ | ||
+ | A 1.5mm hole was drilled into the bottom side of the body to drain any oil that makes it past the umbrella. \\ | ||
+ | |||
+ | |||
+ | {{:techtalk:ref:engmech:homemade_breather_vavle_1_by_norsexl.jpg?direct&300|}} {{:techtalk:ref:engmech:homemade_breather_vavle_3_by_norsexl.jpg?direct&300|}} \\ | ||
+ | |||
+ | {{:techtalk:ref:engmech:homemade_breather_vavle_4_by_norsexl.jpg?direct&300|}} {{:techtalk:ref:engmech:homemade_breather_vavle_5_by_norsexl.jpg?direct&300|}} {{:techtalk:ref:engmech:homemade_breather_vavle_2_by_norsexl.jpg?direct&300|}} \\ | ||