Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
techtalk:ref:oil05a [2019/06/04 23:20] hippysmack [High Pressure Oil Bypass] |
techtalk:ref:oil05a [2019/06/12 18:16] hippysmack |
||
---|---|---|---|
Line 12: | Line 12: | ||
You need to get the oil out of the crankcase so it does not interfere with motion of the crank and cause the heating problem in the first place. \\ | You need to get the oil out of the crankcase so it does not interfere with motion of the crank and cause the heating problem in the first place. \\ | ||
- | The proposed approach is to bleed off excess high pressure oil from the feed side of the oil pump. \\ | + | Some have found it useful to build bypass circuits to bleed off excess oil pressure and send it back to the tank. \\ |
Such that the scavaging side of the pump will be able to evacuate the oil from the crankcase before it starts to wet sump and generate the added heat. \\ | Such that the scavaging side of the pump will be able to evacuate the oil from the crankcase before it starts to wet sump and generate the added heat. \\ | ||
+ | But this does reduce oil pressure across the board, as opposed to opening a bypass when the pressure exceeds a certain point. \\ | ||
+ | |||
+ | {{:techtalk:ref:oil:oil_pressure_bypass_mod_14_by_aswracing.jpg?direct&300|}} ((photo by aswracing of the XLFORUM http://xlforum.net/forums/showpost.php?p=4341107&postcount=6)) | ||
====== Homemade Oil System Bypass (OSB) ====== | ====== Homemade Oil System Bypass (OSB) ====== | ||
Line 220: | Line 223: | ||
**Coincidence**? \\ | **Coincidence**? \\ | ||
This mod is not so different than what the MoCo has already done to 92 and up engines. \\ | This mod is not so different than what the MoCo has already done to 92 and up engines. \\ | ||
- | When the factory got rid of the 86-90 oil pressure regulator, they introduced a oil bleed passage in the oil feed galley of the right case. \\ | + | When the factory got rid of the 86-91 oil pressure regulator, they introduced an oil bleed passage (tiny hole) in the oil feed galley of the right case. \\ |
This relieves some of the pressure while giving some extra oil to the cam gears by way of splashing #2 cam from the feed galley. \\ | This relieves some of the pressure while giving some extra oil to the cam gears by way of splashing #2 cam from the feed galley. \\ | ||
+ | |||
+ | So, on 92 and up engines, one could also say this mod will add a second pressure relief to the feed oil system. \\ | ||
+ | The jet size for this mod may need to be adjusted for these engines. \\ | ||
+ | (to make sure there is still enough pressure to keep proper oil to the lifters during hot idle or low speeds) \\ | ||
+ | |||
+ | | 98 cam chest. ((photo by isiahstites of the XLFORUM and labeled by Hippysmack http://xlforum.net/forums/showthread.php?t=51598&page=5)) | | ||
+ | |{{:techtalk:evo:oil:98_cam_chest_by_isiahstites.jpg?direct&300|}}| | ||
+ | |||
+ | |||
\\ | \\ |