Differences

This shows you the differences between two versions of the page.

--- techtalk:ref:priclutch02 [2019/11/14 04:15]
ixl2relax [Muller Power Clutch - Release Assembly]
+++ techtalk:ref:priclutch02 [2020/01/04 22:52]
ixl2relax ['91-later Alternative Clutch Pack Using XR1200 Parts]
@@ Line 108: / Line 108: @@
 | E1 Claims 400lbs is the max pressure version they make. As shown below,\\ the AIM 480lbs version & the E1 400lbs version may be the same product. |
-{{:techtalk:ref:priclutch:aim-480-equals-e1-400-diaspring-ericz.jpg?400|}} ((EricZ at http://xlforum.net/forums/showpost.php?p=4341497&postcount=87))
+{{:techtalk:ref:priclutch:aim-480-equals-e1-400-diaspring-ericz.jpg?400|}} ((Pics by EricZ at http://xlforum.net/forums/showpost.php?p=4341497&postcount=87))
@@ Line 139: / Line 139: @@
 As regards the bevelled spring, the inside diameter should sit closer to the Hub Base and the outside diameter should sit closer to the Pressure Plate.
+**NOTE-1** With the Judder design, which require additional motion in the clutch compression process, I would expect it to be more difficult to get the correct setting of the adjustment screw (perfectly balanced) to allow enough motion for the plates to get from fully engaged to fully disengaged. Pay close attention when you make the clutch adjustment of the ball & ramp motion.
 (Note: This configuration is a new experiment - implement it as you see fit. Additional notes will be added as more experiences are related on the XLForum regarding the success.)
 **XR Parts to Replace Stock XL Spring Plate**\\

Trace: