Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
techtalk:ref:priclutch02 [2019/11/14 04:16] ixl2relax [Upgrade Clutch Diaphragm Springs - Pressure] |
techtalk:ref:priclutch02 [2020/01/04 22:52] ixl2relax ['91-later Alternative Clutch Pack Using XR1200 Parts] |
||
|---|---|---|---|
| Line 139: | Line 139: | ||
| As regards the bevelled spring, the inside diameter should sit closer to the Hub Base and the outside diameter should sit closer to the Pressure Plate. | As regards the bevelled spring, the inside diameter should sit closer to the Hub Base and the outside diameter should sit closer to the Pressure Plate. | ||
| + | |||
| + | **NOTE-1** With the Judder design, which require additional motion in the clutch compression process, I would expect it to be more difficult to get the correct setting of the adjustment screw (perfectly balanced) to allow enough motion for the plates to get from fully engaged to fully disengaged. Pay close attention when you make the clutch adjustment of the ball & ramp motion. | ||
| + | |||
| (Note: This configuration is a new experiment - implement it as you see fit. Additional notes will be added as more experiences are related on the XLForum regarding the success.) | (Note: This configuration is a new experiment - implement it as you see fit. Additional notes will be added as more experiences are related on the XLForum regarding the success.) | ||
| + | |||
| **XR Parts to Replace Stock XL Spring Plate**\\ | **XR Parts to Replace Stock XL Spring Plate**\\ | ||
