Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
techtalk:ref:svcproc16 [2019/02/14 03:41] hippysmack [Assembly] |
techtalk:ref:svcproc16 [2019/02/23 02:27] hippysmack [Inspection] |
||
|---|---|---|---|
| Line 28: | Line 28: | ||
| ===== Inspection ===== | ===== Inspection ===== | ||
| + | ==== Visual ==== | ||
| + | |||
| |Clean all parts inside and out with solvent ((photos by Hippysmack))|| | |Clean all parts inside and out with solvent ((photos by Hippysmack))|| | ||
| |{{:techtalk:ref:svcproc:lifter_inspect_0_by_hippysmack.jpg?direct&300|}}|{{:techtalk:ref:svcproc:lifter_inspect_7_by_hippysmack.jpg?direct&300|}}| | |{{:techtalk:ref:svcproc:lifter_inspect_0_by_hippysmack.jpg?direct&300|}}|{{:techtalk:ref:svcproc:lifter_inspect_7_by_hippysmack.jpg?direct&300|}}| | ||
| Line 36: | Line 38: | ||
| |Check for excessive wear on the outside of the housing. \\ Excess scratches should signal you to check the lifter bore clearance in the case. ((photos by Hippysmack))||Wear marks from lifter rising above the \\ anti-rotation pin. ((photos by Hippysmack))| | |Check for excessive wear on the outside of the housing. \\ Excess scratches should signal you to check the lifter bore clearance in the case. ((photos by Hippysmack))||Wear marks from lifter rising above the \\ anti-rotation pin. ((photos by Hippysmack))| | ||
| |{{:techtalk:ref:svcproc:lifter_inspect_3_by_hippysmack.jpg?direct&300|}}|{{:techtalk:ref:svcproc:lifter_inspect_4_by_hippysmack.jpg?direct&300|}}|{{:techtalk:ref:svcproc:lifter_inspect_5_by_hippysmack.jpg?direct&300|}}| | |{{:techtalk:ref:svcproc:lifter_inspect_3_by_hippysmack.jpg?direct&300|}}|{{:techtalk:ref:svcproc:lifter_inspect_4_by_hippysmack.jpg?direct&300|}}|{{:techtalk:ref:svcproc:lifter_inspect_5_by_hippysmack.jpg?direct&300|}}| | ||
| + | |||
| + | ==== Mechanical ==== | ||
| + | |||
| |Check roller end clearance with a feeler gauge. ((photo by Hippysmack))| | |Check roller end clearance with a feeler gauge. ((photo by Hippysmack))| | ||
