Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| techtalk:ref:svcproc16 [2020/04/25 18:55] – [Assembly] hippysmack | techtalk:ref:svcproc16 [2024/01/21 21:10] (current) – [Assembly] hippysmack | ||
|---|---|---|---|
| Line 51: | Line 51: | ||
| It can be pushed down with your finger to install the clip. \\ | It can be pushed down with your finger to install the clip. \\ | ||
| But with a lifter half or more full of oil, it's harder to work the plunger with your fingers as the pressure behind the plunger is greater. \\ | But with a lifter half or more full of oil, it's harder to work the plunger with your fingers as the pressure behind the plunger is greater. \\ | ||
| + | In fact, it's nearly impossible to assemble a lifter completely full of oil. \\ | ||
| If you install the lifter into a holder, that frees up both hands and gives better leverage on the plunger. \\ | If you install the lifter into a holder, that frees up both hands and gives better leverage on the plunger. \\ | ||
| The holder below is fabbed from a steel sheet and a welded bushing to hold the lifter. \\ | The holder below is fabbed from a steel sheet and a welded bushing to hold the lifter. \\ | ||
| Line 58: | Line 59: | ||
| The block is used to press the plunger down. A spare pushrod or screwdriver can also be used to depress the plunger. | The block is used to press the plunger down. A spare pushrod or screwdriver can also be used to depress the plunger. | ||
| - | {{: | + | {{: |
| |{{: | |{{: | ||
