Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
techtalk:ref:svcproc23 [2019/01/09 04:09] ixl2relax ↷ Links adapted because of a move operation |
techtalk:ref:svcproc23 [2019/02/02 05:53] hippysmack [Cam Lift] |
||
---|---|---|---|
Line 101: | Line 101: | ||
The duration can be calculated from the published timing figures. \\ | The duration can be calculated from the published timing figures. \\ | ||
- | ===== Cam Lift ===== | + | ===== Cam Lobe Lift ===== |
The actual cam lift is any amount of lift greater (taller) than the base circle. \\ | The actual cam lift is any amount of lift greater (taller) than the base circle. \\ | ||
This corresponds to how far the valves are open. \\ | This corresponds to how far the valves are open. \\ | ||
Line 120: | Line 120: | ||
Check all four cams and compare the results. \\ | Check all four cams and compare the results. \\ | ||
+ | |||
+ | You can also measure cam lobe lift with the cams removed by using a caliper. ((rocketmangb of the XLFORUM http://xlforum.net/forums/showthread.php?s=73d24db8f0756ef41c6215fd92ad0055&p=4726240)) \\ | ||
+ | The base circle is the smallest dimension of a cam lobe. \\ | ||
+ | If you measure the largest dimension of the lobe and subtract the smallest dimension you get the lobe lift. \\ | ||
+ | Multiply that by the rocker ratio and you get the valve lift. \\ | ||