Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
techtalk:ref:svcproc26 [2019/08/06 15:03] hippysmack [Direct Method] |
techtalk:ref:svcproc26 [2019/08/06 15:20] hippysmack [Indirect Method] |
||
|---|---|---|---|
| Line 27: | Line 27: | ||
| But it doesn't work well with heads that have angled domes. \\ | But it doesn't work well with heads that have angled domes. \\ | ||
| + | {{:techtalk:ref:svcproc:1200-1250_squish_band_measurement_by_hippysmack.jpg?direct&300|}} ((drawing by Hippysmack)) | ||
| ===== Direct Method ===== | ===== Direct Method ===== | ||
| Line 34: | Line 35: | ||
| It takes more time than measuring the deck as in above because it requires an extra disassembly/reassembly cycle of the cylinder head. \\ | It takes more time than measuring the deck as in above because it requires an extra disassembly/reassembly cycle of the cylinder head. \\ | ||
| But this method works great with flat or angled head surfaces. The tools required are no more than if you are installing the heads. \\ | But this method works great with flat or angled head surfaces. The tools required are no more than if you are installing the heads. \\ | ||
| - | |||
| - | {{:techtalk:ref:svcproc:squish_band_1_by_aswracing.jpg?direct&300|}} ((photo by aswracing of the XLFORUM )) \\ | ||
| - | \\ | ||
| Place the solder in multiple places around the piston top. \\ | Place the solder in multiple places around the piston top. \\ | ||
| Grease works best to hold the solder but if using tape, keep it below the squish band. \\ | Grease works best to hold the solder but if using tape, keep it below the squish band. \\ | ||
| + | |||
| + | | Solder held with grease. ((photo by aswracing of the XLFORUM ))| | ||
| + | |{{:techtalk:ref:svcproc:squish_band_1_by_aswracing.jpg?direct&300|}}| | ||
| Install the head gaskets and heads then follow the torque procedure to full torque spec. \\ | Install the head gaskets and heads then follow the torque procedure to full torque spec. \\ | ||
