Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Last revision Both sides next revision | ||
|
techtalk:ref:tools023 [2022/01/18 01:49] hippysmack [Using taps / dies to chase debris out of the threads] |
techtalk:ref:tools023 [2022/01/18 01:50] hippysmack [Using taps / dies to chase debris out of the threads] |
||
|---|---|---|---|
| Line 51: | Line 51: | ||
| Likewise, a tap will cut through and remove grime and dried up sealants in the existing threads. \\ | Likewise, a tap will cut through and remove grime and dried up sealants in the existing threads. \\ | ||
| There are some holes, however, that are purposely tapped undersize at the factory. \\ | There are some holes, however, that are purposely tapped undersize at the factory. \\ | ||
| - | Running a standard tap in those holes opens the holes up. | + | Running a standard tap in those holes opens the holes up. \\ |
| (also the low quality taps from the do-it-yourself store are not held to the cutting tolerance that real ground thread H or L limit taps possess) \\ | (also the low quality taps from the do-it-yourself store are not held to the cutting tolerance that real ground thread H or L limit taps possess) \\ | ||
