Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Last revision Both sides next revision | ||
techtalk:ref:tools102 [2018/08/30 22:01] hippysmack [Piston Ring Compressor] |
techtalk:ref:tools102 [2019/03/10 03:52] hippysmack [Piston Rings] |
||
---|---|---|---|
Line 7: | Line 7: | ||
====== Piston Rings ====== | ====== Piston Rings ====== | ||
+ | See also [[techtalk:ref:engmech02e#removing_installing_piston_rings|Removing / Installing Piston Rings]] in the REF section of the Sportsterpedia. \\ | ||
+ | |||
+ | This tool is cheap at most auto parts stores. \\ | ||
+ | It hooks both ends of the ring and spreads it apart making the inside diameter wider than the piston. \\ | ||
+ | Then lift the ring off / on the piston. \\ | ||
+ | **Caution**: only spread the ring just enough to remove / install it. | ||
+ | Used on top and second rings. \\ | ||
+ | (the bottom oil rings are usually removed by hand) | ||
+ | |||
+ | |{{:techtalk:ref:tools:piston_ring_spreader_1_by_hippysmack.jpg?direct&300|}}|{{:techtalk:ref:tools:piston_ring_spreader_2_by_hippysmack.jpg?direct&300|}}| | ||
+ | ===== Piston Ring Remover / Installer ===== | ||
+ | |||
===== Piston Ring Compressor ===== | ===== Piston Ring Compressor ===== | ||
|{{:techtalk:ref:tools:ring_compressor_by_ironmick.jpg?direct&300|}}| | |{{:techtalk:ref:tools:ring_compressor_by_ironmick.jpg?direct&300|}}| | ||
Line 16: | Line 28: | ||
====== Wrist Pin ====== | ====== Wrist Pin ====== | ||
+ | See also [[https://www.suspension.com/blog/how-to-install-a-bushing-without-a-press/|How to install a bushing without a press]] | ||
===== Wrist Pin Removal - Installation Tools ===== | ===== Wrist Pin Removal - Installation Tools ===== | ||
Line 47: | Line 59: | ||
|{{techtalk:ref:tools:connecting_rod_balancing_jig_1_by_saddlebagrail.jpg?direct&300|}}|{{techtalk:ref:tools:connecting_rod_balancing_jig_2_by_saddlebagrail.jpg?direct&300|}}|{{techtalk:ref:tools:connecting_rod_balancing_jig_3_by_saddlebagrail.jpg?direct&300|}}| | |{{techtalk:ref:tools:connecting_rod_balancing_jig_1_by_saddlebagrail.jpg?direct&300|}}|{{techtalk:ref:tools:connecting_rod_balancing_jig_2_by_saddlebagrail.jpg?direct&300|}}|{{techtalk:ref:tools:connecting_rod_balancing_jig_3_by_saddlebagrail.jpg?direct&300|}}| | ||
^ **Jig for Balancing Rods** ((photos by saddlebagrail of the XLFORUM http://xlforum.net/forums/showthread.php?t=395586&page=12)) ^^^ | ^ **Jig for Balancing Rods** ((photos by saddlebagrail of the XLFORUM http://xlforum.net/forums/showthread.php?t=395586&page=12)) ^^^ | ||
+ | ===== Wrist Pin Lock Rings ===== | ||
+ | Installing Spira-lock wrist pin lock rings: | ||
+ | |||
+ | |{{:techtalk:ref:tools:installing_spira-lock_wrist_pin_lock_rings_1_by_saddlebagrail.jpg?direct&300|}}|{{:techtalk:ref:tools:installing_spira-lock_wrist_pin_lock_rings_2_by_saddlebagrail.jpg?direct&300|}}| | ||
+ | |||
+ | |{{:techtalk:ref:tools:installing_spira-lock_wrist_pin_lock_rings_3_by_saddlebagrail.jpg?direct&300|}}|{{:techtalk:ref:tools:installing_spira-lock_wrist_pin_lock_rings_4_by_saddlebagrail.jpg?direct&300|}}|{{:techtalk:ref:tools:installing_spira-lock_wrist_pin_lock_rings_5_by_saddlebagrail.jpg?direct&300|}}| | ||
+ | |{{:techtalk:ref:tools:installing_spira-lock_wrist_pin_lock_rings_6_by_saddlebagrail.jpg?direct&300|}}|{{:techtalk:ref:tools:installing_spira-lock_wrist_pin_lock_rings_7_by_saddlebagrail.jpg?direct&300|}}|{{:techtalk:ref:tools:installing_spira-lock_wrist_pin_lock_rings_8_by_saddlebagrail.jpg?direct&300|}}| | ||