Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
techtalk:ref:tools107 [2019/01/20 01:59] hippysmack [Reamers] |
techtalk:ref:tools107 [2019/01/20 02:01] hippysmack [Reamers] |
||
|---|---|---|---|
| Line 22: | Line 22: | ||
| ===== Reamers ===== | ===== Reamers ===== | ||
| **Cam cover bushings**: \\ | **Cam cover bushings**: \\ | ||
| - | The reamers for the cam cover need to be chamfered (chucking) reamers. \\ | + | The reamers for the cam cover bushings (#1, #3 and #4) need to be chamfered (chucking) reamers. \\ |
| The ends have a short chamfer that will enter the blind bushing bore and not hit the rear of the bore before finished cutting the bushings. \\ | The ends have a short chamfer that will enter the blind bushing bore and not hit the rear of the bore before finished cutting the bushings. \\ | ||
| The reamer for #2 cam can be a tapered bridge reamer on models with nosecone ignitions. \\ | The reamer for #2 cam can be a tapered bridge reamer on models with nosecone ignitions. \\ | ||
