Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
techtalk:ref:tools107 [2019/10/19 04:25] hippysmack [Bushing Removal] |
techtalk:ref:tools107 [2019/10/19 04:34] hippysmack [Bushing Installation] |
||
|---|---|---|---|
| Line 42: | Line 42: | ||
| Below are a couple homemade tools for installing the bushings. A knocking rod and a compression plate. \\ | Below are a couple homemade tools for installing the bushings. A knocking rod and a compression plate. \\ | ||
| - | {{:techtalk:ref:tools:homemade_cam_bushing_tools_3_by_fergerburger.jpg?direct&300|}} ((photo by fergerburger of the XLFORUM http://xlforum.net/forums/showthread.php?t=1349714)) | + | The knocker rod is made from 1" aluminum bar stock with a .030" shoulder to recess into the bearing, .030" into the case. ((fergerburger of the XLFORUM http://xlforum.net/forums/showthread.php?t=1349714)) \\ |
| + | |||
| + | The compression plate is made from a scrap steel plate. The bolts screw in to push the bushings in place. See the [[techtalk:ref:tools107#reverse_engineered_cam_bushing_installer|build pics]] below by Hippysmack. \\ | ||
| + | |||
| + | {{:techtalk:ref:tools:homemade_cam_bushing_tools_3_by_fergerburger.jpg?direct&300|}} ((photo by fergerburger of the XLFORUM http://xlforum.net/forums/showthread.php?t=1349714)) {{techtalk:ref:tools:cam_bushing_installer_41_by_hippysmack.jpg?direct&300|}} ((photo by Hippysmack)) {{techtalk:ref:tools:cam_bushing_installer_39_by_hippysmack.jpg?direct&300|}} ((photo by Hippysmack)) | ||
| ===== Modified Cover for Reaming ===== | ===== Modified Cover for Reaming ===== | ||
