Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
techtalk:ref:tools109 [2019/08/01 22:55]
hippysmack [Telescoping Bore Gauge (snap gauge)]
techtalk:ref:tools109 [2019/08/01 23:19] (current)
hippysmack [Telescoping Bore Gauge (snap gauge)]
Line 45: Line 45:
   * Evo cylinders will naturally not be perfectly (a few thousandths variance in circumference). \\ To measure cylinder bore, the heads have to be off which releases the torque on the cylinder and distorts the bore.   * Evo cylinders will naturally not be perfectly (a few thousandths variance in circumference). \\ To measure cylinder bore, the heads have to be off which releases the torque on the cylinder and distorts the bore.
  
 +|{{:​techtalk:​ref:​tools:​measuring_the_circumference_1_by_hippysmack.jpg?​direct&​300|}}|{{:​techtalk:​ref:​tools:​measuring_the_circumference_2_by_hippysmack.jpg?​direct&​300|}}|
 +|Measure around the circumference for accurate readings. \\ One measurement will most likely not give an accurate description of the bore. ((photos by Hippysmack))||
  
 |{{:​techtalk:​ref:​tools:​measuring_cylinder_1_by_horseman1.jpg?​direct&​300|}}|{{:​techtalk:​ref:​tools:​measuring_cylinder_2_by_horseman1.jpg?​direct&​300|}}| |{{:​techtalk:​ref:​tools:​measuring_cylinder_1_by_horseman1.jpg?​direct&​300|}}|{{:​techtalk:​ref:​tools:​measuring_cylinder_2_by_horseman1.jpg?​direct&​300|}}|