Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
techtalk:ref:tools110 [2019/07/03 22:22] hippysmack [Bike Lifts / Jacks] |
techtalk:ref:tools110 [2019/07/03 22:35] hippysmack [Jack Stands] |
||
---|---|---|---|
Line 10: | Line 10: | ||
===== Jack Stands ===== | ===== Jack Stands ===== | ||
**Homemade Jack Stands**: \\ | **Homemade Jack Stands**: \\ | ||
+ | |||
+ | These were made specifically for a bike with a center stand. ((Toejam503 of the XLFORUM http://xlforum.net/forums/showthread.php?p=5760229#post5760229)) \\ | ||
+ | With these you can lift the front wheel off the ground when doing tires, wheel bearings, forks, etc. \\ | ||
+ | On a bike without a center stand, you can use the kickstand as a pivot. \\ | ||
+ | These little stands can be placed, strategically, under the frame for stability while working. \\ | ||
+ | |||
+ | Base: 4.5" of 1"x2" C-channel iron. \\ | ||
+ | Shaft welded to center of base: Iron conduit 1" OD approx. 4" high. \\ | ||
+ | A 15/16" nut is welded to top of shaft. \\ | ||
+ | The nuts were welded to the base for stability of the assembly. \\ | ||
+ | However, you could add a nut (un-welded) on top of the that one for more adjustability. \\ | ||
+ | First, measure your individual clearance to get the overall (collapsed) height that you can use. \\ | ||
+ | The top is made from a threaded rod welded to metal C-channel (saddles). \\ | ||
+ | |||
|{{:techtalk:ref:tools:homemade_jac_stands_1_by_toejam503.jpg?direct&300|}}|{{:techtalk:ref:tools:homemade_jac_stands_2_by_toejam503.jpg?direct&300|}}|{{:techtalk:ref:tools:homemade_jac_stands_3_by_toejam503.jpg?direct&300|}}| | |{{:techtalk:ref:tools:homemade_jac_stands_1_by_toejam503.jpg?direct&300|}}|{{:techtalk:ref:tools:homemade_jac_stands_2_by_toejam503.jpg?direct&300|}}|{{:techtalk:ref:tools:homemade_jac_stands_3_by_toejam503.jpg?direct&300|}}| | ||
^ Homemade jack stands. ((photos by Toejam503 of the XLFORUM http://xlforum.net/forums/showthread.php?p=5760229#post5760229)) ^^^ | ^ Homemade jack stands. ((photos by Toejam503 of the XLFORUM http://xlforum.net/forums/showthread.php?p=5760229#post5760229)) ^^^ |