Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
techtalk:ref:tools116 [2019/11/10 01:35]
hippysmack [Engine Sprocket and Clutch Removal / Installation]
techtalk:ref:tools116 [2019/11/10 02:18] (current)
hippysmack [5 Speed]
Line 25: Line 25:
  
 ===== 5 Speed ===== ===== 5 Speed =====
 +Any of these '​wedges'​ can be used but be sure not to put pressure on the shifter shaft with them. \\
  
- +|{{techtalk:​ref:​transfinal:​engine-clutch_sprocket_locks_by_vafish.jpg?​direct&​300|}}|{{techtalk:​ref:​tools:​primary-brasshinge-lock.jpg?​300|}}| 
-|{{techtalk:​ref:​transfinal:​engine-clutch_sprocket_locks_by_vafish.jpg?​direct&​300|}}| +|A heavy duty 4" door hinge works well. \\ A cheap 4" door hinge bends like a pretzel. \\ The derilin block just gets shredded up. \\ But, the heavy duty 4" hinge works great. ((VaFish http://​xlforum.net/​forums/​showthread.php?​t=1997193))|A closed 4" BRASS hinge also works well. ((photo by Scuba10jdl of the XLFORUM ​ http://​xlforum.net/​forums/​showthread.php?​t=53268))|
-|A heavy duty 4" door hinge works well. \\ A cheap 4" door hinge bends like a pretzel. \\ The derilin block just gets shredded up. \\ But, the heavy duty 4" hinge works great. ((VaFish http://​xlforum.net/​forums/​showthread.php?​t=1997193))| ​+
  
 |{{techtalk:​ref:​svcproc:​sprocketholdingtool_1_by_hippysmack.jpg?​direct&​300|}}|{{techtalk:​ref:​tools:​sprocketholdingtool_2_by_hippysmack.jpg?​direct&​300|}}| |{{techtalk:​ref:​svcproc:​sprocketholdingtool_1_by_hippysmack.jpg?​direct&​300|}}|{{techtalk:​ref:​tools:​sprocketholdingtool_2_by_hippysmack.jpg?​direct&​300|}}|
 |  Home made sprocket lock 4.19" x 1.5" x 5/16" steel with beveled edges ((photos by Hippysmack http://​xlforum.net/​forums/​showthread.php?​t=1848977)) ​ || |  Home made sprocket lock 4.19" x 1.5" x 5/16" steel with beveled edges ((photos by Hippysmack http://​xlforum.net/​forums/​showthread.php?​t=1848977)) ​ ||
  
 +
 +\\  ​